ANNEX V, Regulation (EU) 2017/1151

In forcesince 1 Sep 2023cited 2×

1.1. This Annex describes the procedure for the type 3 test verifying emissions of crankcase gases as described in section 5.3.3. of UN/ECE Regulation No 83.

2.1. The general requirements for conducting the type 3 test shall be those set out in sections 1 and 2 of Annex 6 to UN/ECE Regulation No 83, with the exceptions set out in points 2.2 and 2.3 below.

2.2. Reference to the Type I test in paragraph 2.1. of Annex 6 to UN/ECE Regulation No 83 shall be understood as referring to the Type 1 test in Annex XXI to this Regulation.

2.3. The road load coefficients to be used shall be those for vehicle low (VL). If VL does not exist, then the VH road load shall be used. In that case VH is defined in accordance with point 4.2.1.1.1 of Annex B4 to UN Regulation No 154. In case the interpolation method is used VL and VH are specified in point 4.2.1.1.2 of Annex B4 to UN Regulation No 154. Alternatively, the manufacturer may choose to use road loads that have been determined in accordance with the provisions of Appendix 7a or Appendix 7b to Annex 4a to UN/ECE Regulation No 83 for a vehicle included in the interpolation family.

3.1. The technical requirements shall be those set out in section 3 to 6 of Annex 6 to UN/ECE Regulation No 83, with the exception set out in point 3.2 below.

3.2. References to the Type I test in paragraph 3.2. of Annex 6 to UN/ECE Regulation No 83 shall be understood as referring to the Type 1 test in Annex XXI to this Regulation.