In the case of an electric powertrain component being type approved in accordance with this Annex, the component shall bear:
1.1. The manufacturer’s name or trade mark
1.2. The make and identifying type indication as recorded in the information referred to in paragraph 0.2 and 0.3 of Appendixes 2 to 6 of this Annex
1.3. The certification mark (if applicable) as a rectangle surrounding the lower-case letter “e” followed by the distinguishing number of the Member State which has granted the certificate:
1 for Germany; | 19 for Romania;
2 for France; | 20 for Poland;
3 for Italy; | 21 for Portugal;
4 for the Netherlands; | 23 for Greece;
5 for Sweden; | 24 for Ireland;
6 for Belgium; | 25 for Croatia;
7 for Hungary; | 26 for Slovenia;
8 for Czechia; | 27 for Slovakia;
9 for Spain; | 29 for Estonia;
12 for Austria; | 32 for Latvia;
13 for Luxembourg; | 34 for Bulgaria;
17 for Finland; | 36 for Lithuania;
18 for Denmark; | 49 for Cyprus;
50 for Malta
1.4. The certification mark shall also include in the vicinity of the rectangle the “base certification number” as specified for Section 4 of the type-approval number set out in Annex IV to Regulation (EU) 2020/683 preceded by the two figures indicating the sequence number assigned to the latest technical amendment to this Regulation and by an alphabetical character indicating the part for which the certificate has been granted:
For this Regulation, the sequence number shall be 02.
For this Regulation, the alphabetical character shall be the one laid down in Table 1.
M | electric machine system (EMS)
I | integrated electric powertrain component (IEPC)
H | integrated HEV powertrain component (IHPC) Type 1
B | battery system
A | capacitor system
1.4.1. Example and dimensions of the certification mark
The above certification mark affixed to an electric powertrain component shows that the type concerned has been approved in Austria (e12), pursuant to this Regulation. The first two digits (02) are indicating the sequence number assigned to the latest technical amendment to this Regulation. The following letter indicates that the certificate was granted for an electric machine system (M). The last five digits (00005) are those allocated by the type-approval authority to the electric machine system as the base certification number.
1.5 Upon request of the applicant for a certificate and after prior agreement with the type-approval authority other type sizes than indicated in 1.4.1 may be used. Those other type sizes shall remain clearly legible.
1.6 The markings, labels, plates or stickers must be durable for the useful life of the electric powertrain component and must be clearly legible and indelible. The manufacturer shall ensure that the markings, labels, plates or sticker cannot be removed without destroying or defacing them.
1.7 The certification mark shall be visible when the electric powertrain component is installed on the vehicle and shall be affixed to a part necessary for normal operation and not normally requiring replacement during component life.
2.1. Certification number for an electric powertrain component shall comprise the following:
eX*YYYY/YYYY*ZZZZ/ZZZZ*X*00000*00
section 1 | section 2 | section 3 | Additional letter to section 3 | section 4 | section 5
Indication of country issuing the certificate | HDV CO2 determination Regulation “2017/2400” | Latest amending Regulation (ZZZZ/ZZZZ) | See Table 1 of this appendix | Base certification number 00000 | Extension 00