The standard torque losses for axles are shown in Table 1. The standard table values consist of the sum of a generic constant efficiency value covering the load dependent losses and a generic basic drag torque loss to cover the drag losses at low loads.
Tandem axles shall be calculated using a combined efficiency for an axle including drive-thru (SRT, HRT) plus the matching single axle (SR, HR).
Basic function |
Generic efficiency
η
Drag torque
(wheel side)
Td0 = T0 + T1 × igear
Single reduction axle (SR) | 0,98 |
T0 = 70 Nm
T1 = 20 Nm
Single reduction tandem axle (SRT) / single portal axle (SP) | 0,96 |
T0 = 80 Nm
T1 = 20 Nm
Hub reduction axle (HR) | 0,97 |
T0 = 70 Nm
T1 = 20 Nm
Hub reduction tandem axle (HRT) | 0,95 |
T0 = 90 Nm
T1 = 20 Nm
All other axle technologies | 0,90 |
T0 = 150 Nm
T1 = 50 Nm
The basic drag torque (wheel side) Td0 is calculated by
Td0 = T0 + T1 × igear
using the values from Table 1.
The standard torque loss Tloss,std on the input side of the axle is calculated by
Tloss,std
Td0
Tout
η
Tout
igear
where:
Tloss,stdStandard torque loss at the input side [Nm]
Td0Basis drag torque over the complete speed range [Nm]
igearAxle gear ratio [-]
ηGeneric efficiency for load dependent losses [-]
Touttorque [Nm]
The corresponding torque (at input side) of the axle shall be calculated by
Tin
Tout
igear
Tloss,std
where:
TinInput torque [Nm]’;