69 Appendix 3, Regulation (EU) 2017/735

In forcesince 14 Feb 2017

In this Appendix 3 the stock culture of Myriophyllum spicatum L [Carl von Linné (* May, 23th, 1707 in Råshult/Älmhult; † January, 10th, 1778 in Uppsala).], a submersed aquatic dicotyledon, a species of the water milfoils family is described. Between June and August, inconspicuous pink-white flowers protrude above the water surface. The plants are rooted in the ground by a system of robust rhizomes and can be found in the entire northern hemisphere in eutrophic, however non-polluted and more calciferous still waters with muddy substrate. Myriophyllum spicatum prefers fresh water, but is found in brackish water as well.

For sediment-free stock culture under laboratory conditions, sterile plants are required. Sterile plants are available from the ecotoxicology laboratory of the German Umweltbundesamt (Federal Environment Agency of Germany).

Alternatively, test organisms can be prepared from non-sterile plants in accordance with ASTM designation E 1913-04. See below — extracted from the ASTM Standard Guide — the procedure for culturing Myriophyllum sibiricum collected from field:

“If starting from field collected, non-sterile plants, collect M. sibiricum turions in the autumn. Place the turions into a 20-l aquarium containing 5 cm of sterile sediment that is covered with silica sand or for example by Turface® and 18 l of reagent water. Aerate the aquarium and maintain at a temperature of 15 °C and a fluence rate of 200 to 300 μmol m– 2 s– 1 for 16 h per day. The plant culture in the aquarium may be maintained as a backup source of plants in case the sterile plant cultures are destroyed by mechanical malfunction in the growth cabinet, contamination, or other reason. The plants grown in the aquarium are not sterile and sterile cultures cannot be maintained in a batch culturing system. To sterilize the culture, plants are removed from the aquarium and rinsed under flowing deionized water for about 0,5 h. Under aseptic conditions in a laminar airflow cabinet, the plants are disinfected for less than 20 min (until most of the plant tissue is bleached and just the growing apex is still green) in a 3 % (w/v) sodium hypochlorite solution containing 0,01 % of a suitable surfactant. Agitate the disinfectant and plant material. Segments with several nodes are transferred into sterile culture tubes containing 45 ml of sterilized modified Andrews' medium and capped with plain culture tube closures. Only one plant segment is placed into each test chamber. Laboratory sealant film is used to secure the closure to the culture vessel. Once a sterile culture has been established, plant segments containing several nodes should be transferred to new test chambers containing fresh liquid nutrient media every ten to twelve days. As demonstrated by culturing on agar plates, the plants must be sterile and remain sterile for eight weeks before testing can be initiated.”

Since the modified Andrews' medium contains sucrose (which stimulates the growth of fungi and bacteria), all material, solutions and culturing be conducted under sterile conditions. All liquids as well as equipment are sterilised before use. Sterilisation is carried out via heated air treatment (210 °C) for 4 hours or autoclaving for 20 minutes at 121 °C. In addition, all flasks, dishes, bowls etc and other equipment undergo flame treatment at the sterile workbench just prior to use.

Stock cultures can be maintained under reduced illumination and temperature (50 μE m– 2 s– 1, 20 ± 2 °C) for longer times without needing to be re-established. The Myriophyllum growth medium should be the same as that used for testing but other nutrient rich media can be used for stock cultures.

The plant segments are distributed axenically over several 500 ml Erlenmeyer or/and 2000 ml Fernbach flasks, each filled with approximately 450 respectively 1000 ml modified Andrews' medium. Then, the flasks are axenically cellulose plug stoppered.

In addition, thorough flame treatment of equipment at the sterile workbench just prior to use is absolutely necessary. Dependent on number and size, the plants are to be transferred into fresh nutrient solution approximately every three weeks.

Apices as well as segments of the stem middle part for this renewed culture can be used. Number and size of transferred plants (or segments of plants) are dependent on how many plants are needed. For example, you can transfer five shoot segments into one Fernbach flask and three shoot segments into one Erlenmeyer flask, each with a length of 5 cm. Discard any rooted, flowering, dead or otherwise conspicuous parts.

Culturing of plants is to be performed in 500 ml Erlenmeyer and 2000 ml Fernbach flasks in a cooling incubator at 20 ± 2 °C with continuously light at approximately 100-150 μE m– 2 s– 1 or 6000-9000 Lux (emitted by chamber illumination with colour temperature “warm white light”).

Chemically clean (acid-washed) and sterile glass culture vessels should be used and aseptic handling techniques employed. In the event of contamination of the stock culture e.g. by algae, fungi and/or bacteria a new culture should be prepared or a stock culture from another laboratory should be used to renewal of the one culture.