, Decision_act (EU) 1986/398

In force

THE FACTS

1.

The present Decision arises from investigations made in October 1983 under Article 14 (3) of Council Regulation N° 17 with most of the producers of the bulk thermoplastic polypropylene supplying the EEC market. During the investigations the Commission discovered documentary evidence showing that the majority of the suppliers of polypropylene in the EEC had participated on a regular basis since about the end of 1977 in an institutionalized system of meetings between representatives of the producers at both senior and technical managerial levels (the so-called 'bosses'' and 'experts'' meetings). In these meetings, which came to be held on a twice-monthly basis and

were supplemented by ad hoc local meetings for each Member State, the producers developed a system of annual volume control to share out the available market between themselves according to agreed percentage or tonnage targets and regularly set target prices which were implemented in a series of so-called price 'initiatives'. The four major producers, ICI, Hoechst, Montepolimeri and Shell (the last of which did not however attend regular bosses' or experts' meetings) formed an unofficial directorate known as the 'big four', with the perceived task of leading and encouraging the smaller producers in implementing the various schemes.

A. The market

I.

The product

2.

The product which is the subject of this Decision is polypropylene, one of the principal bulk thermoplastic polymers, invented in 1954. It is derived ultimately from crude oil. Naphtha, the basic raw material for the petrochemical industry, is obtained from oil and then reformed or 'cracked' to produce inter alia propylene, the feedstock for polypropylene.

Polypropylene is sold by the producers to processors for conversion into either finished or semi-finished products. A number of producers are vertically integrated into the processing sector. Conversion may be carried out by extrusion, injection moulding or blow moulding according to the particular application.

3.

The largest producers of polypropylene have a range of more than a hundred different grades covering a wide range of end uses.

For ease of reference, the major basic grades of polypropylene can be taken to be raffia (or fibre), homopolymer injection moulding, copolymer injection moulding, high impact copolymer and film.