47 SUBPART L COMMUNICATION AND NAVIGATION EQUIPMENT, Commission Regulation (EC) No 859/2008 of 20 August 2008 amending Council Regulation (EE…

In forcesince 20 Aug 2008
(a)

An operator shall ensure that a flight does not commence unless the communication and navigation equipment required under this Subpart is:

1.

Approved and installed in accordance with the requirements applicable to them, including the minimum performance standard and the operational and airworthiness requirements;

2.

Installed such that the failure of any single unit required for either communication or navigation purposes, or both, will not result in the failure of another unit required for communications or navigation purposes;

3.

In operable condition for the kind of operation being conducted except as provided in the MEL (OPS 1.030 refers); and

4.

So arranged that if equipment is to be used by one flight crew member at his/her station during flight it must be readily operable from his/her station. When a single item of equipment is required to be operated by more than one flight crew member it must be installed so that the equipment is readily operable from any station at which the equipment is required to be operated.

(b)

Communication and navigation equipment minimum performance standards are those prescribed in the applicable European Technical Standard Orders (ETSO) as listed in applicable specifications on European Technical Standard Orders (CS-TSO), unless different performance standards are prescribed in the operational or airworthiness codes. Communication and navigation equipment complying with design and performance specifications other than ETSO on the date of OPS implementation may remain in service, or be installed, unless additional requirements are prescribed in this Subpart. Communication and navigation equipment which has already been approved does not need to comply with a revised ETSO or a revised specification, other than ETSO, unless a retroactive requirement is prescribed.

(a)

An operator shall not operate an aeroplane unless it is equipped with radio required for the kind of operation being conducted.

(b)

Where two independent (separate and complete) radio systems are required under this Subpart, each system must have an independent antenna installation except that, where rigidly supported non-wire antennae or other antenna installations of equivalent reliability are used, only one antenna is required.

(c)

The radio communication equipment required to comply with paragraph (a) above must also provide for communications on the aeronautical emergency frequency 121,5 MHz.

An operator shall not operate an aeroplane under IFR unless it is equipped with an audio selector panel accessible to each required flight crew member.

An operator shall not operate an aeroplane under VFR over routes that can be navigated by reference to visual landmarks, unless it is equipped with the radio communication equipment necessary under normal operating conditions to fulfil the following:

(a)

Communicate with appropriate ground stations;

(b)

Communicate with appropriate air traffic control facilities from any point in controlled airspace within which flights are intended; and

(c)

Receive meteorological information.

(a)

An operator shall not operate an aeroplane under IFR, or under VFR over routes that cannot be navigated by reference to visual landmarks, unless the aeroplane is equipped with radio communication and SSR transponder and navigation equipment in accordance with the requirements of air traffic services in the area(s) of operation.

(b)

Radio equipment. An operator shall ensure that radio equipment comprises not less than:

1.

two independent radio communication systems necessary under normal operating conditions to communicate with an appropriate ground station from any point on the route including diversions; and

2.

SSR transponder equipment as required for the route being flown.

(c)

for short-haul operations in the NAT MNPS airspace not crossing the North Atlantic, an aeroplane may be equipped with one long range communication system (HF-system) only if alternative communication procedures are published for the airspace concerned.

(d)

Navigation equipment. An operator shall ensure that navigation equipment

1.

Comprises not less than:

(i)

one VOR receiving system, one ADF system, one DME except that an ADF system need not be installed provided that the use of the ADF is not required in any phase of the planned flight;

(ii)

one ILS or MLS where ILS or MLS is required for approach navigation purposes;

(iii)

one marker beacon receiving system where a marker beacon is required for approach navigation purposes;

(iv)

an area navigation system when area navigation is required for the route being flown;

(v)

an additional DME system on any route, or part thereof, where navigation is based only on DME signals;

(vi)

an additional VOR receiving system on any route, or part thereof, where navigation is based only on VOR signals;

(vii)

an additional ADF system on any route, or part thereof, where navigation is based only on NDB signals; or

2.

complies with the required navigation performance (RNP) type for operation in the airspace concerned.

(e)

An operator may operate an aeroplane that is not equipped with an ADF or with the navigation equipment specified in subparagraph(s) (c)1(vi) and/or (c)1(vii) above, provided that it is equipped with alternative equipment authorised, for the route being flown, by the Authority. The reliability and the accuracy of alternative equipment must allow safe navigation for the intended route.

(f)

An operator shall ensure that VHF communication equipment, ILS Localiser and VOR receivers installed on aeroplanes to be operated in IFR are of a type that has been approved as complying with the FM immunity performance standards.

(g)

An operator shall ensure that aeroplanes conducting ETOPS have a communication means capable of communicating with an appropriate ground station at normal and planned contingency altitudes. For ETOPS routes where voice communication facilities are available, voice communications shall be provided. For all ETOPS operations beyond 180 minutes, reliable communication technology, either voice based or data link, must be installed. Where voice communication facilities are not available and where voice communication is not possible or is of poor quality, communications using alternative systems must be ensured.

(a)

An operator shall not operate an aeroplane unless it is equipped with:

1.

a pressure altitude reporting SSR transponder; and

2.

any other SSR transponder capability required for the route being flown.

(a)

An operator shall not operate an aeroplane in MNPS airspace unless it is equipped with navigation equipment that complies with minimum navigation performance specifications prescribed in ICAO Doc 7030 in the form of regional supplementary procedures.

(b)

The navigation equipment required by this paragraph must be visible and usable by either pilot seated at his/her duty station.

(c)

For unrestricted operation in MNPS airspace an aeroplane must be equipped with two independent long range navigation systems (LRNS).

(d)

For operation in MNPS airspace along notified special routes an aeroplane must be equipped with one long range navigation system (LRNS), unless otherwise specified.

(a)

An operator shall ensure that aeroplanes operated in RVSM airspace are equipped with:

1.

two independent altitude measurement systems;

2.

an altitude alerting system;

3.

an automatic altitude control system; and

4.

a secondary surveillance radar (SSR) transponder with altitude reporting system that can be connected to the altitude measurement system in use for altitude keeping.

(a)

An operator shall not use a navigation database which supports an airborne navigation application as a primary means of navigation unless the navigation database supplier holds a Type 2 Letter of Acceptance (LoA) or equivalent.

(b)

If the operator's supplier does not hold a Type 2 LoA or equivalent, the operator shall not use the electronic navigation data products unless the Authority has approved the operator's procedures for ensuring that the process applied and the delivered products have met equivalent standards of integrity.

(c)

An operator shall not use electronic navigation data products for other navigation applications unless the Authority has approved the operator's procedures for ensuring that the process applied and the delivered products have met standards of integrity acceptable for the intended use of the data.

(d)

An operator shall continue to monitor both the process and the products according to the requirements of OPS 1.035.

(e)

An operator shall implement procedures that ensure timely distribution and insertion of current and unaltered electronic navigation data to all aircraft that require it.