30 SUBPART H PERFORMANCE CLASS B, Commission Regulation (EC) No 859/2008 of 20 August 2008 amending Council Regulation (EE…

In forcesince 20 Aug 2008
(a)

An operator shall not operate a single-engine aeroplane:

1.

at night; or

2.

in instrument meteorological conditions except under special visual flight rules.

Note: Limitations on the operation of single-engine aeroplanes are covered by OPS 1.240(a)6.

(b)

An operator shall treat two-engine aeroplanes which do not meet the climb requirements of Appendix 1 to OPS 1.525(b) as single-engine aeroplanes.

(a)

An operator shall ensure that the take-off mass does not exceed the maximum take-off mass specified in the Aeroplane Flight Manual for the pressure altitude and the ambient temperature at the aerodrome at which the take-off is to be made.

(b)

An operator shall ensure that the unfactored take-off distance, as specified in the Aeroplane Flight Manual does not exceed:

1.

when multiplied by a factor of 1,25, the take-off run available; or

2.

when stop way and/or clearway is available, the following:

(i)

the take-off run available;

(ii)

when multiplied by a factor of 1,15, the take-off distance available; and

(iii)

when multiplied by a factor of 1,3, the accelerate-stop distance available.

(c)

When showing compliance with subparagraph (b) above, an operator shall take account of the following:

1.

the mass of the aeroplane at the commencement of the take-off run;

2.

the pressure altitude at the aerodrome;

3.

the ambient temperature at the aerodrome;

4.

the runway surface condition and the type of runway surface;

5.

the runway slope in the direction of take-off; and

6.

Not more than 50 % of the reported head-wind component or not less than 150 % of the reported tail-wind component.

(a)

An operator shall ensure that the take-off flight path of aeroplanes with two or more engines, determined in accordance with this subparagraph, clears all obstacles by a vertical margin of at least 50 ft, or by a horizontal distance of at least 90 m plus 0,125 x D, where D is the horizontal distance travelled by the aeroplane from the end of the take-off distance available or the end of the take-off distance if a turn is scheduled before the end of the take-off distance available except as provided in subparagraphs (b) and (c) below. For aeroplanes with a wingspan of less than 60 m a horizontal obstacle clearance of half the aeroplane wingspan plus 60 m, plus 0,125 x D may be used. When showing compliance with this subparagraph it must be assumed that:

1.

the take-off flight path begins at a height of 50 ft above the surface at the end of the take-off distance required by OPS 1.530 (b) and ends at a height of 1500 ft above the surface;

2.

the aeroplane is not banked before the aeroplane has reached a height of 50 ft above the surface, and that thereafter the angle of bank does not exceed 15°;

3.

failure of the critical engine occurs at the point on the all engine take-off flight path where visual reference for the purpose of avoiding obstacles is expected to be lost;

4.

the gradient of the take-off flight path from 50 ft to the assumed engine failure height is equal to the average all-engine gradient during climb and transition to the en-route configuration, multiplied by a factor of 0,77; and

5.

the gradient of the take-off flight path from the height reached in accordance with subparagraph 4 above to the end of the take-off flight path is equal to the one engine inoperative en-route climb gradient shown in the Aeroplane Flight Manual.

(b)

When showing compliance with subparagraph (a) above for those cases where the intended flight path does not require track changes of more than 15°, an operator need not consider those obstacles which have a lateral distance greater than:

1.

300 m, if the flight is conducted under conditions allowing visual course guidance navigation, or if navigational aids are available enabling the pilot to maintain the intended flight path with the same accuracy (see Appendix 1 to OPS 1.535 (b)1. and (c)1.); or

2.

600 m, for flights under all other conditions.

(c)

When showing compliance with subparagraph (a) above for those cases where the intended flight path requires track changes of more than 15°, an operator need not consider those obstacles which have a lateral distance greater than:

1.

600 m for flights under conditions allowing visual course guidance navigation (see Appendix 1 to OPS 1.535 (b)1 and (c)1);

2.

900 m for flights under all other conditions.

(d)

When showing compliance with subparagraphs (a), (b) and (c) above, an operator must take account of the following:

1.

the mass of the aeroplane at the commencement of the take-off run;

2.

the pressure altitude at the aerodrome;

3.

the ambient temperature at the aerodrome; and

4.

not more than 50 % of the reported head-wind component or not less than 150 % of the reported tail-wind component.

(a)

An operator shall ensure that the aeroplane, in the meteorological conditions expected for the flight, and in the event of the failure of one engine, with the remaining engines operating within the maximum continuous power conditions specified, is capable of continuing flight at or above the relevant minimum altitudes for safe flight stated in the Operations Manual to a point 1000 ft above an aerodrome at which the performance requirements can be met.

(b)

When showing compliance with subparagraph (a) above:

1.

the aeroplane must not be assumed to be flying at an altitude exceeding that at which the rate of climb equals 300 ft per minute with all engines operating within the maximum continuous power conditions specified; and

2.

the assumed en-route gradient with one engine inoperative shall be the gross gradient of descent or climb, as appropriate, respectively increased by a gradient of 0,5 %, or decreased by a gradient of 0,5 %.

(a)

An operator shall ensure that the aeroplane, in the meteorological conditions expected for the flight, and in the event of engine failure, is capable of reaching a place at which a safe forced landing can be made. For landplanes, a place on land is required, unless otherwise approved by the Authority.

(b)

When showing compliance with subparagraph (a) above:

1.

the aeroplane must not be assumed to be flying, with the engine operating within the maximum continuous power conditions specified, at an altitude exceeding that at which the rate of climb equals 300 ft per minute; and

2.

the assumed en-route gradient shall be the gross gradient of descent increased by a gradient of 0,5 %.

An operator shall ensure that the landing mass of the aeroplane determined in accordance with OPS 1.475 (a) does not exceed the maximum landing mass specified for the altitude and the ambient temperature expected for the estimated time of landing at the destination and alternate aerodrome.

(a)

An operator shall ensure that the landing mass of the aeroplane determined in accordance with OPS 1.475 (a) for the estimated time of landing allows a full stop landing from 50 ft above the threshold within 70 % of the landing distance available at the destination aerodrome and at any alternate aerodrome.

1.

The Authority may approve the use of landing distance data factored in accordance with this paragraph based on a screen height of less than 50 ft, but not less than 35 ft (see Appendix 1 to OPS 1.550 (a)).

2.

The Authority may approve short landing operations, in accordance with the criteria in Appendix 2 to OPS 1.550 (a).

(b)

When showing compliance with subparagraph (a) above, an operator shall take account of the following:

1.

the altitude at the aerodrome;

2.

not more than 50 % of the head-wind component or not less than 150 % of the tail-wind component.

3.

the runway surface condition and the type of runway surface; and

4.

the runway slope in the direction of landing;

(c)

For despatching an aeroplane in accordance with subparagraph (a) above, it must be assumed that:

1.

the aeroplane will land on the most favourable runway, in still air; and

2.

the aeroplane will land on the runway most likely to be assigned considering the probable wind speed and direction and the ground handling characteristics of the aeroplane, and considering other conditions such as landing aids and terrain.

(d)

If an operator is unable to comply with subparagraph (c)2 above for the destination aerodrome, the aeroplane may be despatched if an alternate aerodrome is designated which permits full compliance with subparagraphs (a), (b) and (c) above.

(a)

An operator shall ensure that when the appropriate weather reports or forecasts, or a combination thereof, indicate that the runway at the estimated time of arrival may be wet, the landing distance available is equal to or exceeds the required landing distance, determined in accordance with OPS 1.550, multiplied by a factor of 1,15.

(b)

An operator shall ensure that when the appropriate weather reports or forecasts, or a combination thereof, indicate that the runway at the estimated time of arrival may be contaminated, the landing distance, determined by using data acceptable to the Authority for these conditions, does not exceed the landing distance available.

(c)

A landing distance on a wet runway shorter than that required by subparagraph (a) above, but not less than that required by OPS 1.550 (a), may be used if the Aeroplane Flight Manual includes specific additional information about landing distances on wet runways.