Art. 6 Regulation (EU) 2025/1706

Application for emission type-approval of a vehicle

In forcesince 25 Jul 2025cited 1×
1.

The manufacturer shall submit to the approval authority an application for emission type-approval of a vehicle under Regulation (EU) 2024/1257. The application referred to in paragraph 1 shall be drawn up in accordance with the model of the information document set out in Appendix 3 to Annex I.

2.

In addition, the manufacturer shall submit to the granting type-approval authority the following information:

3.

In the case of vehicles equipped with positive-ignition engines, a declaration by the manufacturer of the minimum percentage of misfires out of a total number of firing events that would either result in emissions exceeding the OBD thresholds laid out in Table 4A of paragraph 6.8.2 of UN Regulation No 154, if that percentage had been present from the start of a type 1 test as chosen for the demonstration in accordance with Annex C5 to UN Regulation No 154, or could lead to an exhaust catalyst or catalysts overheating prior to causing irreversible damage;

(a)

a description of the malfunction indicator used by the OBD system to signal the presence of a fault to a driver of the vehicle;

(b)

a declaration by the manufacturer that the OBD system complies with the OBD requirements laid down in Annex XI;

(c)

a description of the measures taken to prevent tampering with and modification of the emission control systems, complying with Annex XIV and including the emission control computer and odometer including the recording of lifetime values for the purposes of the requirements of Annexes XI and XVI;

(d)

if applicable, the particulars of the vehicle family as referred to in paragraph 6.8.1 of UN Regulation No 154;

(e)

where appropriate, copies of other type-approvals with the relevant data to enable extension of approvals.

4.

For the purposes of paragraph 3, point (d), the measures taken to prevent tampering with and modification of the emission control computer shall include the facility for updating using a manufacturer-approved programme or calibration.

5.

For the tests specified in Figure I.2.3 of Annex I, the manufacturer shall submit to the technical service responsible for the emission type-approval tests a vehicle representative of the type to be approved.

6.

The application for emission type-approval of mono fuel, bi-fuel and flex- fuel vehicles shall comply with the additional requirements laid down in Sections 1.1 and 1.2 of Annex I.

7.

Changes to the make of a system, component or separate technical unit that occur after a type-approval shall not automatically invalidate the type-approval, unless its original characteristics or technical parameters are changed in such a way that the functionality of the engine or pollution control system and the resulting emissions are affected.

8.

The manufacturer shall provide the granting type-approval authority a package on testing transparency in the format specified in Table A4/2 of paragraph 5.9 of Annex 4 to UN Regulation No 83 and in Tables 1 and 2 of Appendix 5 of Annex 4 to UN Regulation No 83 as amended by Annex II to this Regulation.

9.

The manufacturer shall upload all the in-service conformity related data required under Annex 4 to UN Regulation No 83 and Annex II to this Regulation into the electronic platform for ISC for vehicles covered by the emission type-approval.