The manufacturer shall ensure that replacement pollution control devices intended to be fitted to emission type-approved vehicles covered by the scope of Regulation (EU) 2024/1257 are emission type-approved as separate technical units in accordance with Article 13 and Annex XIII to this Regulation.
The requirements for pollution control devices laid down in this Article shall be deemed to be met if the replacement pollution control devices have been approved according to UN Regulation No 103 [UN Regulation No 103 – Uniform provisions concerning the approval of replacement pollution control devices for power-driven vehicles (OJ L 207, 10.8.2017, p. 30, ELI: http://data.europa.eu/eli/reg/2007/103(2)/oj).].
For the purposes of this Regulation, catalytic converters and particulate filters shall be considered to be pollution control devices.
Original equipment replacement pollution control devices, which fall within the type covered by point 2.3 of the Addendum to Annex A2 of UN Regulation No 154 and are intended for fitment to a vehicle to which the relevant type-approval document refers, do not need to comply with Annex XIII to this Regulation if they fulfil the requirements of points 2.1 and 2.2 of Annex XIII to this Regulation.
The manufacturer shall ensure that the original pollution control device carries identification markings.
The identification markings referred to in paragraph 3 shall comprise the following:
the vehicle or engine manufacturer’s name or trade mark;
the make and identifying part number of the original pollution control device as recorded in the information referred to in point 3.2.12.2 of Annex A1 to UN Regulation No 154.