Neither would smelters that currently produce high-purity aluminium other than P0404 (whether higher or lower grades of purity) shift to P0404 as a result of a small but significant non transitory increase in the price of P0404. Although such smelters would have the technical capability of producing P0404, they would not have the economic incentive to do so. Aluminium of higher purity than P0404 commands higher margins (premiums) which would have to be abandoned for the sake of a shift of production to P0404. Although the conversion cost per se may not be considerable - in the sense that such smelters have the necessary equipment to produce high-purity aluminium (point feeders and computer controls) - the operating costs of the conversion would exceed the revenues, adjusted for actual yield, even with a significant price increase in P0404. According to a CRU report on high-purity aluminium, if a smelter were to decide to try to dedicate some of its production to high-purity, the capital-cost requirement could vary quite considerably depending upon the technology and equipment already employed at the smelter. Further, operating costs at a smelter shifting to P0404 are estimated to rise by approximately 53 USD/t. Moreover, even if a smelter had point feeders and computer controls, there would still be additional capital costs, such as 20-50 USD/t to install repiping and 15 USD/t in lost production profits while conversion is taking place. Accordingly, on the basis of the additional operating costs and the yield of P0404, conversion to P0404 would be unprofitable, as the additional return from the conversion would be 24-49 USD/t - that is, below the extra operating costs of 53 USD/t. Thus, although smelters presently producing other purity grades could convert to P0404, they have no economic incentive to do so even if prices increase significantly. Indeed, smelters told CRU that they "have taken a conscious decision not to attempt to produce high-purity aluminium following a cost-benefit analysis". That is the reason why the market has seen no actual conversions of any smelters to P0404 in recent years. The Commission has questioned smelters currently producing high-purity aluminium (although not necessarily P0404), either in large and consistent quantities, or in limited quantities or as a by-product. They stated that, as a result of a small but significant non transitory increase in the P0404 price, they would not shift their high-purity aluminium production to P0404. Smelters that occasionally produce P0404 as a by-product of more efficient operations (for instance, of P0202 production) said that they would not envisage increasing or streamlining their output of P0404. One of the reasons cited was the relatively small demand for P0404 compared with the disproportionate investment in terms of finance, time, human resources, working methods and the high operating costs. In particular, smelters based in the USA stated that, in the short run, it would also be unworkable to increase any of their P0404 production in the event of a price increase, owing to the current US environmental regulations that would discourage such an expansion(23). Consequently, aluminium of a higher degree of purity is not part of the P0404 market.
Recital 94, Decision_act (EU) 2002/174
In forcesince 3 May 2000