ANNEX IX: COMMUNICATION CONCERNING THE TYPE APPROVAL OF A VEHICLE WITH REGARD TO BRAKING, Directive (EU) 1991/422

In forcesince 22 Aug 1991

Item 7 shall read:

‘7. | Distribution of the mass on each axle (maximum value) …’

.Item 8 shall read:

‘8.

Make and type of brake linings …

8.1. Alternative brake linings …

8.1.1. Approval test method: vehicle tests/Annex XII/other (4) …’

8.1. Alternative brake linings …

8.1.1. Approval test method: vehicle tests/Annex XII/other (4) …’

.Item 9.4.3. shall read:

‘9.4.3. | centre axle trailer: indicate also the …’

After item 9.4.4. the following new item 9.4.5. shall be added:

‘9.4.5. | trailer category o: braked/unbraked (4)’

After item 9.5. the following new item 9.6. shall be added:

‘9.6. | vehicle is/is not (4) equipped to tow a trailer with anti-lock devices.’

Item 13 shall read:

‘13. | Mass of vehicle at …’

.Item 14.2. shall read:

‘14.2. | Type O test

engine connected

service braking

in accordance with Annex II

paragraph 2.1.1.1.1…’

.3rd column of table shall read: ‘Measured force applied to the control (N).’Item 14.5. shall read:

‘14.5. | Braking device(s) used during the Type II/II A (4) test’

.Item 14.6. shall read:

‘14.6.

Response time and …

14.6.1. Response time at …

14.6.2. Response time at …’

14.6.1. Response time at …

14.6.2. Response time at …’

Item 14.7.2. shall read:

‘14.7.2.’

‘14.7.3. shall read:

‘14.7.3.’

Item 14.7.4. In the table, references to ‘residual’ shall read ‘hot’.After item 19.2. the following new items 20 and 21 shall be added:

‘20. | Automatic braking on trailers with compressed air brakaing system

20.1. Braking rate achieved …

21.

Trailers with electrical braking systems

21.1. Does the vehicle fulfill the requirements contained in Annex XI: yes/no (4).

21.2. Braking rate achieved …’

Items 20 to 27 shall be renumbered as items 22 to 29.The footnote shall read: ‘( 1 ) In the case of a semi-trailer, indicate here the mass corrsponding to the load on the fifth wheel.’