T.1
Competent authority
…
SECTION A
TECHNICAL REQUIREMENTS
SUBPART A
GENERAL
T.A.101
Scope
This section establishes requirements to ensure that continuing airworthiness of aircraft referred to in point (b) of Article 1 is maintained in compliance with the essential requirements of Annex V to Regulation (EU) No 2018/1139 of the European Parliament and of the Council.
It also specifies the conditions to be met by the persons and organisations responsible for management of the continuing airworthiness and maintenance of such aircraft.
SUBPART B
CONTINUING AIRWORTHINESS
T.A.201
Responsibilities
1.
The operator is responsible for the airworthiness of the aircraft and it shall ensure that it is not operated unless the aircraft has a type certificate issued or validated by the CAA;
the aircraft is in an airworthy condition;
the aircraft holds a valid certificate of airworthiness issued in accordance with ICAO Annex 8;
the maintenance of the aircraft is performed in accordance with a maintenance programme which shall comply with the requirements of the State of Registry and the applicable requirements of ICAO Annex 6.
any defect or damage affecting the safe operation of the aircraft is rectified to a standard acceptable to the State of Registry;
the aircraft complies with any applicable:
airworthiness directive or continued airworthiness requirement issued or adopted by the State of Registry; and
mandatory safety information issued by the CAA, including airworthiness directives;
a release to service is issued to the aircraft after maintenance by qualified organisations in compliance with the State of Registry requirements. The signed release to service shall contain, in particular, the basic details of the maintenance carried out.
the aircraft is inspected, through a pre-flight inspection, before each flight
all modifications and repairs comply with the airworthiness requirements established by the State of Registry
the following aircraft records are available until the information contained has been superseded by new information equivalent in scope and detail but not less than 24 months:
the total time in service (hours, cycles and calendar time, as appropriate) of the aircraft and all life-limited components;
current status of compliance with T.A.201 (1)(f) requirements;
current status of compliance with the maintenance programme;
current status of modifications and repairs together with appropriate details and substantiating data to demonstrate that they comply with the requirements established by the State of Registry.
2.
The tasks specified in T.A.201 (1) shall be controlled by the operator's continuing airworthiness management organisation. For this purpose the organisation shall comply with the additional requirements of T.A. Subpart G.
3.
The continuing airworthiness management organisation referred to in point (2) shall ensure that the maintenance and release of the aircraft are performed by a maintenance organisation meeting the requirements of Subpart E of this Annex (Part-T). For this purpose, when the continuing airworthiness management organisation does not meet those requirements itself, it shall establish a contract with a maintenance organisation meeting those requirements.
SUBPART E
MAINTENANCE ORGANISATION
T.A. 501
Maintenance Organisation
The continuing airworthiness management organisation shall ensure that the aircraft and its components are maintained by organisations complying with the following requirements:
The organisation holds a maintenance organisation approval issued or acceptable to the State of Registry.
The scope of approval of the organisation includes the appropriate aircraft and/or component capability.
The organisation has established an occurrence reporting system which ensures that any identified condition of an aircraft or component which endangers the flight safety is reported to the operator, the CAA, the organisation responsible for the type design or supplemental type design and the continuing airworthiness management organisation.
The organisation has established an organisation's manual providing a description of all the procedures of the organisation.
SUBPART G
ADDITIONAL REQUIREMENTS FOR CONTINUING AIRWORTHINESS MANAGEMENT ORGANISATIONS APPROVED PURSUANT TO ANNEX Vc (Part-CAMO)
T.A.701
Scope
This Subpart establishes the requirements to be met, in addition to the requirements of Annex Vc (Part-CAMO), by an organisation approved in accordance with that Annex, for it to be entitled to control the carrying out of the tasks specified in point T.A.201.
T.A.704
Continuing airworthiness management exposition
In addition to the requirements provided for in point CAMO.A.300, the exposition shall contain procedures specifying how the organisation ensures compliance with this Annex.
T.A.706
Personnel requirements
In addition to the requirements provided for in point CAMO.A.305, the personnel referred to in points (a)(3) to (a)(5) and (b)(2) of point CAMO.A.305 shall have adequate knowledge of the applicable laws of the third countries where the aircraft is registered.
T.A.708
Continuing airworthiness management
Notwithstanding point CAMO.A.315, for aircraft for which the continuing airworthiness is managed in accordance with the requirements of this Annex the organisation shall:
ensure that the aircraft is taken to a maintenance organisation whenever necessary;
ensure that all maintenance is carried out in accordance with the maintenance programme;
ensure the application of the T.A.201 (1)(f) mandatory information;
ensure that all defects discovered during scheduled maintenance or reported are corrected by the maintenance organisation in accordance with the maintenance data acceptable to the State of Registry;
coordinate scheduled maintenance, the application of the T.A.201 (1)(f) mandatory information, the replacement of life-limited parts, and component inspection to ensure the work is carried out properly;
manage and archive the continuing airworthiness records required by T.A.201 (1)(j);
ensure that modifications and repairs are approved in accordance with the requirements of the State of Registry.
T.A.709
Documentation
Notwithstanding point CAMO.A.325, for every aircraft for which the continuing airworthiness is managed in accordance with the requirements of this Annex, the organisation shall hold and use applicable maintenance data acceptable to the State of registry of the aircraft.
T.A.711
Privileges
An organisation approved in accordance with Annex Vc (Part-CAMO) may perform the tasks specified in point T.A.708 for the aircraft included in its air operator certificate, provided that the organisation has established procedures, approved by the CAA, in order to ensure compliance with the requirements of this Annex.
T.A.712
Management system
In addition to the requirements of point CAMO.A.200, the organisation shall ensure its compliance with the requirements of this Annex.
T.A.714
Record-keeping
In addition to the requirements of point (a) of point CAMO.A.220, the organisation shall keep the records referred to in point (1)(j) of point T.A.201.
T.A.715
Continued validity
For the approval of an organisation managing the continuing-airworthiness to remain valid, the following requirements shall be met in addition to the requirements of point CAMO.A.135:
the organisation complies with the applicable requirements of this Annex; and
the organisation ensures that any person authorised by the CAA is granted access to any of its facilities, aircraft or documents related to its activities, including any subcontracted activities, to determine compliance with this Annex.
T.A.716
Findings
After having received a notification of findings in accordance with point T.B.705, the organisation shall do the following:
identify the root cause or causes of, and contributing factors to the finding of non-compliance;
prepare, adopt and implement a corrective action plan;
demonstrate to the satisfaction of the CAA that the necessary corrective action to address the finding has been taken.
The actions referred to in points (1) to (3) of paragraph (a) shall be performed within the time period set by the CAA in accordance with point T.B.705.
SECTION B
ADDITIONAL PROCEDURE …
SUBPART A
GENERAL
T.B.101
Scope
This Section establishes the administrative requirements to be followed by the CAA for the purposes of the application and enforcement of Section A of this Part-T.
T.B.102
The CAA
1.
General
The CAA shall establish documented procedures and an organisational structure.
2.
Resources
The number of staff shall be appropriate to carry out the requirements as detailed in this Section
3.
Qualification and training
All staff involved in Part-T activities shall be appropriately qualified and have the appropriate knowledge, experience, initial training and continuation training to perform their allocated tasks.
4.
Procedures
The CAA shall establish procedures detailing how compliance with this Part is accomplished.
T.B.104
Record-keeping
1.
The requirements of M.B.104(a), (b) and (c) of Annex I shall apply.
2.
The minimum records for the oversight of each aircraft shall include, at least, a copy of:
the aircraft's certificate of airworthiness,
all relevant correspondence relating to the aircraft,
reports from any inspection and survey performed to the aircraft,
details of any exemption and enforcement action(s).
3.
All records specified in T.B.104 shall be made available, upon request, to … the State of Registry.
4.
The records specified in (2) shall be retained until 4 years after the end of the dry lease-in period.
T.B.105
Mutual exchange of information
…
SUBPART B
ACCOUNTABILITY
T.B.201
Responsibilities
1.
The CAA is responsible for conducting inspections and investigations, including aircraft surveys, in order to verify that the requirements of this Part are complied with.
2.
The CAA shall perform inspections and investigations before the approval of the dry lease in agreement in accordance with ARO.OPS.110 (a)(1), to verify that the requirements of T.A.201 are then complied with.
3.
The CAA shall ensure coordination with the State of Registry as necessary to exercise the oversight responsibilities of the aircraft contained in this Annex Va (Part-T).
T.B.202
Findings
1.
A level 1 finding is any significant non-compliance with the Part-T requirements which lowers the safety standard and hazards seriously the flight safety.
2.
A level 2 finding is any non-compliance with the Part-T requirements which could lower the safety standard and possibly hazard the flight safety.
3.
When a finding is detected during inspections, investigations, aircraft surveys or by other means, the CAA shall:
take measures as necessary, such as the grounding of the aircraft, to prevent the continuation of the non-compliance,
require corrective actions appropriate to the nature of the finding to be taken.
4.
For level 1 findings, the CAA shall require appropriate corrective action to be taken before further flight and notify the State of Registry.
SUBPART G
ADDITIONAL REQUIREMENTS FOR CONTINUING AIRWORTHINESS MANAGEMENT ORGANISATIONS APPROVED PURSUANT TO ANNEX Vc (Part-CAMO)
T.B.702
Initial certification procedure
In addition to the requirements of point CAMO.B.310, the CAA shall verify and establish that those procedures comply with the requirements of this Annex and it shall verify that the organisation complies with the requirements of this Annex.
T.B.704
Continuing oversight
In addition to the requirements of point CAMO.B.305, during each oversight planning cycle, the CAA shall survey a relevant sample of aircraft referred to in point (b) of Article 1 managed by the organisation.
T.B.705
Findings and corrective actions
For organisations managing the continuing airworthiness of aircraft referred to in point (b) of Article 1, the CAA shall apply the requirements contained in point CAMO.B.350 when verifying if the organisation complies with the requirements of this Annex.