Measures to ensure in-service conformity of vehicles type-approved under this Regulation shall be taken in accordance with the conformity of production arrangements as laid down in Article 31 of Regulation (EU) 2018/858,Annex IV to Regulation (EU) 2018/858 and Annex II to this Regulation.
The in-service conformity checks shall be appropriate for confirming that tailpipe and evaporative emissions are effectively limited during the normal life of vehicles under normal conditions of use.
In-service conformity shall be checked on properly maintained and used vehicles, in accordance with Appendix 1 of Annex II, between 15000 km or 6 months whichever occurs later and 100000 km or 5 years whichever occurs sooner. In service conformity for evaporative emissions shall be checked on properly maintained and used vehicles, in accordance with Appendix 1 of Annex II, between 30000 km or 12 months whichever occurs later and 100000 km or 5 years whichever occurs sooner.
The requirements for in-service conformity checks are applicable until 5 years after the last Certificate of Conformity or individual approval certificate is issued for vehicles of that in-service conformity family.
In-service conformity checks shall not be mandatory if the annual sales of the in-service conformity family are less than 5000 vehicles in the Union for the previous year. For such families, the manufacturer shall provide the approval authority with a report of any emissions related warranty and relevant repair as set out in point 4 of Annex II. Such in-service conformity families may still be selected to be tested in accordance with Annex II.
The manufacturer and the granting type approval authority shall perform in-service conformity checks in accordance with Annex II. Other type approval authorities, technical services, the Commission and third parties may perform parts of the in-service conformity checks in accordance with Annex II. The data required to perform such checks are regulated in the Commission Implementing Regulation 2022/163 [Commission Implementing Regulation (EU) 2022/163 of 7 February 2022 laying down the rules on the application of Regulation (EU) 2018/858 of the European Parliament and of the Council as regards functional requirements for market surveillance of vehicles, systems, components and separate technical units (OJ L 27, 8.2.2022, p. 1).] and Annex II of this Regulation.
The granting approval authority shall take the decision on whether a family failed the provisions of in-service conformity, following a compliance assessment and approve the plan of remedial measures presented by the manufacturer in accordance with Annex II.
If a type approval authority, technical service, the Commission or a third party has established that an in-service conformity family fails the in-service conformity check, it shall notify without delay the granting type approval authority, in accordance with Article 54(1) of Regulation (EU) 2018/858.
Following that notification and subject to the provisions of Article 54(5) of Regulation (EU) 2018/858, the granting approval authority shall inform the manufacturer that an in-service conformity family fails the in-service conformity checks and that the procedures laid out in points 6 and 7 of Annex II shall be followed.
If the granting approval authority establishes that no agreement can be reached with a type approval authority that has established that an in-service conformity family fails the in-service conformity check, the procedure pursuant to Article 54(5) of Regulation (EU) 2018/858 shall be initiated.
In addition to paragraphs 1 to 7, the following shall apply to vehicles type approved in accordance with Annex II.
vehicles submitted to multi-stage type-approval, as defined in Article 3(8) of Regulation EU 2018/858, shall be checked for in-service conformity in accordance with the provisions for multistage approval set out in point 5.10.6 of Annex II to this Regulation;
hearses as specified in Appendix 1 of Part III of Annex II to Regulation EU 2018/858, armoured vehicles as defined in Appendix 2 of Part III of Annex II to Regulation EU 2018/858 and wheelchair accessible vehicles as defined in Appendix 3 of Part III of Annex II to Regulation EU 2018/858 shall not be subject to the provisions of this Article. All other special purpose vehicles as defined in Appendix 4 of Part III of Annex II to Regulation EU 2018/858, shall be checked for in- service conformity in accordance with the rules for multistage type-approvals set out in Annex II to this Regulation.