The manufacturer shall ensure that replacement pollution control devices intended to be fitted to EC type-approved vehicles covered by the scope of Regulation (EC) No 715/2007 are EC type-approved, as separate technical units within the meaning of Article 10(2) of Directive 2007/46/EC, in accordance with Articles 12 and 13 and Annex XIII to this Regulation.
Catalytic converters and particulate filters shall be considered to be pollution control devices for the purposes of this Regulation.
The relevant requirements shall be deemed to be met if the replacement pollution control devices have been approved according to UN/ECE Regulation No 103 [Regulation No 103 of the Economic Commission for Europe of the United Nations (UNECE) — Uniform provisions concerning the approval of replacement pollution control devices for power-driven vehicles (OJ L 207, 10.8.2017, p. 30).].
Original equipment replacement pollution control devices, which fall within the type covered by point 2.3 of the Addendum to Appendix 4 to Annex I and are intended for fitment to a vehicle to which the relevant type-approval document refers, do not need to comply with Annex XIII provided they fulfil the requirements of points 2.1 and 2.2 of that Annex.
The manufacturer shall ensure that the original pollution control device carries identification markings.
The identification markings referred to in paragraph 3 shall comprise the following:
the vehicle or engine manufacturer's name or trade mark;
the make and identifying part number of the original pollution control device as recorded in the information referred to in point 3.2.12.2 of Appendix 3 to Annex I.