In Annex 1, Product Sectors, Chapter 17, Lifts should be deleted and replaced by the following one:
Provisions covered by Article 1(2)
European Union |
Directive 2014/33/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of the Member States relating to lifts and safety components for lifts (OJ L 96, 29.3.2014, p. 251)
Switzerland |
Federal Law of 12 June 2009 on product safety (RO 2010 2573)
Ordinance of 19 May 2010 on product safety (RO 2010 2583), as last amended on 15 June 2012 (RO 2012 3631)
Ordinance of 25 November 2015 on the safety of lifts (RO 2016 219)
Ordinance of 17 June 1996 on the Swiss accreditation system and on the designation of test laboratories and conformity assessment bodies (RO 1996 1904), as last amended on 25 November 2015 (RO 2016 261)
The Committee established under Article 10 of this Agreement shall draw up and keep up to date, according to the procedure described in Article 11 of the Agreement, a list of the conformity assessment bodies.
The Committee established under Article 10 of this Agreement shall draw up and keep up to date a list of the designating authorities notified by the Parties.
For the designation of conformity assessment bodies, the designating authorities shall comply with the general principles contained this Agreement and the assessment criteria set out in Chapter 4 of Directive 2014/33/EU.
Pursuant to the legislation under Section I, economic operators established in the EU or Switzerland are subject to equivalent obligations.
In order to avoid unnecessary duplication of obligations:
for the purpose of the obligations in Articles 8(6) and 10(3) of Directive 2014/33/EU and the corresponding Swiss provisions, it shall be sufficient to indicate the name, registered trade name or registered trade mark and the postal address at which the manufacturer established within the territory of either the European Union or Switzerland can be contacted. In case the manufacturer is not established within the territory of either the European Union or Switzerland, it shall be sufficient to indicate the name, registered trade name or registered trade mark and the postal address at which the importer established within the territory of either the European Union or Switzerland can be contacted;
for the purpose of the obligations in Article 8(3) and 10(8) of Directive 2014/33/EU and the corresponding Swiss provisions, it shall be sufficient that the manufacturer established within the territory of either the European Union or Switzerland keep the technical documentation and the EU declaration of conformity or, where applicable, the attestation of conformity for 10 years after the safety component for lifts has been placed on the market in either the European Union or Switzerland. In case the manufacturer is not established within the territory of either the European Union or Switzerland, it shall be sufficient that the importer established within the territory of either the European Union or Switzerland keep a copy of the EU declaration of conformity or, where applicable, the attestation of conformity at the disposal of the market surveillance authorities and ensure that the technical documentation can be made available to those authorities upon request for 10 years after the safety component for lifts has been placed on the market in either the European Union or Switzerland;
for the purpose of the obligations in Articles 8(4), second subparagraph, and 10(6) of Directive 2014/33/EU and the corresponding Swiss provisions, it shall be sufficient that such obligations be fulfilled by the manufacturer established within the territory of either the European Union or Switzerland, or, in case the manufacturer is not established within the territory of either the European Union or Switzerland, by the importer established within the territory of either the European Union or Switzerland.
For the purpose of the obligation in Article 9(2) of Directive 2014/33/EU and the corresponding Swiss provisions, authorised representative shall mean any natural or legal person established within the European Union or Switzerland who has received a written mandate from a manufacturer to act on his behalf pursuant to Article 9(1) of Directive 2014/33/EU or the corresponding Swiss provisions.
The competent national market surveillance authority of a Member State of the European Union or Switzerland may, on reasoned request, ask the relevant economic operators in the European Union and in Switzerland to provide all the information and documentation necessary to demonstrate the conformity of a product with the legislation in Section I.
That authority may contact the economic operator established within the territory of the other Party either directly or with the assistance of the competent national market surveillance authority of the other Party. It may request manufacturers or, where applicable, authorised representatives and importers to provide the documentation in a language easily understood by that authority. It may request the economic operators to cooperate on any action taken to eliminate the risks posed by the product.
Swiss designating authorities may take part in the exchange of experience between the Member States' national authorities referred to in Article 35 of Directive 2014/33/EU.
Swiss designated conformity assessment bodies may take part in the coordination and cooperation mechanisms provided for in Article 36 of Directive 2014/33/EU, directly or by means of designated representatives.
Pursuant to Article 9(1) of the Agreement, the Parties shall ensure efficient cooperation and exchange of information between their market surveillance authorities. The market surveillance authorities of Member States and Switzerland shall cooperate and exchange information. They shall give each other assistance on an adequate scale by supplying information or documentation concerning economic operators based in a Member State or in Switzerland.
Pursuant to Article 12(4) of this Agreement, where the market surveillance authorities of a Member State or Switzerland have taken action or have sufficient reason to believe that a lift or a safety component for lifts covered by this chapter presents a risk to the health or safety of persons or, where appropriate, to the safety of property, covered by the legislation in Section I of this Chapter, and if they consider that non-compliance is not restricted to their national territory, they shall inform the European Commission, the other Member States and Switzerland without delay of:
the results of the evaluation and of the actions which they have required the economic operators to take,
where the installer does not take adequate corrective action, all appropriate provisional measures taken to prohibit or restrict the placing on their national market or the use of the lift concerned, or to recall it,
where the relevant economic operator does not take adequate corrective action, all appropriate provisional measures taken to prohibit or restrict the safety component for lifts being made available on their national market, to withdraw the safety component for lifts from that market or to recall it.
This information shall include all available details, in particular the data necessary for the identification of the non-compliant lift or safety component for lifts, their origin, the nature of the non-compliance alleged and the risk involved, the nature and duration of the national measures taken and the arguments put forward by the relevant economic operator. In particular, it shall be indicated whether the non-compliance is due to either:
failure of the lift or the safety component for lifts to meet requirements relating to the health and safety requirements referred to in the legislation in Section I, or
shortcomings in the harmonised standards referred to in the legislation in Section I.
Switzerland, or Member States shall without delay inform the European Commission and the other national authorities of any measures adopted and of any additional information at their disposal relating to the non-compliance of the lift or the safety component for lifts concerned.
Member States and Switzerland shall ensure that appropriate restrictive measures are taken in respect of the lift or the safety component for lifts concerned, such as withdrawal of the lift or safety component for lifts from their market, without delay.
Should Switzerland or a Member State disagree with the notified national measure in paragraph 5, it shall inform the European Commission of its objections within three months of the receipt of the information.
Where, on completion of the procedure set out in paragraph 5, objections are raised by a Member State or Switzerland against a measure taken by Switzerland or a Member State or where the Commission considers a national measure to be contrary to the relevant legislation referred to in Section I, the European Commission shall without delay enter into consultation with the Member States, Switzerland, and via the Swiss authorities the relevant economic operator or operators. It shall evaluate the national measure, in order to determine whether the national measure is justified or not.
If the national measure relating to a lift is considered justified, all Member States and Switzerland shall take the measures necessary to ensure that the placing on the market or use of the non-compliant lift concerned is restricted or prohibited, or that the lift is recalled, and shall inform the Commission accordingly.
If the national measure relating to a safety component for lift is considered justified, all Member States and Switzerland shall take the measures necessary to ensure that the non-compliant safety component for lifts is withdrawn from their markets, and shall inform the Commission accordingly.
If the national measure is considered unjustified, the Member State concerned or Switzerland shall withdraw that measure.
A Party may forward the issue to the Committee established under Article 10 of this Agreement, pursuant to paragraph 8.
Where a Member State or Switzerland finds that, although a lift or a safety component for lifts that an economic operator has made available on the EU and on the Swiss market is in compliance with the legislation referred to in Section I of this Chapter, it presents a risk to the health or safety of persons and, where appropriate, the safety of property, it shall take all appropriate measures and immediately inform the Commission, other Member States and Switzerland. That information shall include all available details, in particular the data necessary for the identification of the lift or safety component for lifts concerned, the origin and the supply chain of the product, the nature of the risk involved and the nature and duration of the national measures taken.
The Commission shall without delay enter into consultation with the Member States, Switzerland, and via the Swiss authorities the relevant economic operator or operators, and shall evaluate the national measures taken, in order to determine whether the national measure is justified or not, and where necessary, propose appropriate measures.
A Party may forward the issue to the Committee established under Article 10 of this Agreement, pursuant to paragraph 8.
In case of a disagreement between the Parties on measures pursuant to paragraphs 6 and 7 above, the issue will be forwarded to the Committee, which will decide on an appropriate course of action, including the possibility to have an expert study carried out.
Where the Committee considers that the measure is:
justified, the Parties shall take the measures necessary to ensure that the product is withdrawn from their market;
unjustified, the national authority of the Member State or Switzerland shall withdraw the measure.’