Pollutant | Fuel type | ELV (mg/Nm3)
50-100 MW | > 100-300 MW | > 300-500 MW | > 500 MW
SO2 | Coal, lignite and other solid fuels (Note 1) | 400 | 250 | 200
Biomass (Note 1) | 200
Peat (Note 1) | 300 | 200
Liquid |
350
(Note 2)
250
(Note 2)
200
(Note 3)
Gaseous |
35 in general
5 for liquefied gas
400 for low calorific gases from coke oven
200 for low calorific gases from blast furnace
NOx | Coal, lignite and other solid fuels |
300
(Notes 4 and 5)
200
(Note 5)
200
(Note 6)
Biomass and peat |
300
(Note 5)
250
(Note 5)
200
(Note 5)
200
(Note 6)
Liquid | 450 |
200
(Notes 5 and 7)
150
(Notes 5 and 7)
150
(Note 3)
Natural gas (Note 8) | 100
Other gases | 300 | 200
Dust | Coal, lignite and other solid fuels | 30 | 25 | 20
Biomass and peat | 30 | 20
Liquid | 30 | 25 | 20
Gaseous |
5 in general
10 for blast furnace gas
30 for gases produced by the steel industry which can be used elsewhere
The reference oxygen content is 6 % for solid fuels and 3 % for liquid and gaseous fuels.
800 mg/Nm3 for plants which do not operate more than 1500 operating hours per year.
850 mg/Nm3 for plants which do not operate more than 1500 operating hours per year.
400 mg/Nm3 for plants which do not operate more than 1500 operating hours per year.
450 mg/Nm3 in case of pulverised lignite combustion.
450 mg/Nm3 for plants which do not operate more than 1500 operating hours per year.
450 mg/Nm3 for plants which were granted a permit before 1 July 1987 and which do not operate more than 1500 operating hours per year.
450 mg/Nm3 for plants in chemical installations using liquid production residues as non-commercial fuel for own consumption.
Naturally occurring methane with not more than 20 % (by volume) of inerts and other constituents.
ELV for NOx
(mg/Nm3)
Gas engines (firing gaseous fuels) | 100
Gas turbines (including CCGT) firing the following fuels:
Natural gas (Note 1) |
50
(Notes 2, 3 and 4)
Gaseous fuels other than natural gas |
120
(Note 5)
Light and middle distillates |
90
(Note 5)
The reference oxygen content is 15 %.
Natural gas is naturally occurring methane with not more than 20 % (by volume) of inerts and other constituents.
75 mg/Nm3 in the following cases (where the efficiency of the gas turbine is determined at ISO base load conditions):
gas turbines, used in combined heat and power systems having an overall efficiency greater than 75 %,
gas turbines used in combined cycle plants having an annual average overall electrical efficiency greater than 55 %,
gas turbines for mechanical drives.
For single cycle gas turbines not falling into any of the categories mentioned under Note 2, but having an efficiency greater than 35 % (at ISO base load conditions), the ELV shall be 50 × η/35 where η is the gas turbine efficiency (at ISO base load conditions) expressed as a percentage.
150 mg/Nm3 for plants which do not operate more than 1500 operating hours per year.
200 mg/Nm3 for plants which do not operate more than 1500 operating hours per year.
Total rated thermal input | Minimum rate of desulphurisation
50-100 MW | 80 %
> 100-300 MW | 90 %
> 300 MW |
96 % in general
95 % for plants firing oil shale