8 ANNEX 7 PROCEDURE FOR LOAD/SPEED ENDURANCE TESTS (in principle in accordance with Regulation No 54), Decision_act (EU) 2006/443

In force
1.

Preparing the tyre

1.1. Mount a retreaded tyre on the test rim specified by the retreader.

1.2. Use a new inner tube or combination of inner tube, valve and flap (as required) when testing tyres with inner tubes.

1.3. Inflate the tyre to the pressure corresponding to the pressure index as specified in paragraph 3.2.10 of this Regulation.

1.4. Condition the tyre and wheel assembly at test-room temperature for not less than 3 hours.

1.5. Readjust the tyre pressure to that specified in paragraph 1.3 of this Annex.

2.

Test procedure

2.1. Mount the tyre and wheel assembly on the test axle and press it against the outer face of a smooth surfaced power-driven test drum 1,70 m ± 1 % diameter having a surface at least as wide as the tyre tread. In certain cases a 2,00 m ± 1 % diameter drum may be used.

2.2. Apply to the test axle a series of test loads equal to a percentage of the load indicated in Annex 4 to this Regulation, corresponding to the load index indicated on the tyre, and in accordance with the test programme below. Where the tyre has load capacity indices for operation in both single and twin or dual formation the load corresponding to the load index for single operation shall be used for the test.

2.2.1. In the case of a tyre with a load index ≤ 121 and a speed symbol ≥ Q (160 km/h), the test procedure shall be as specified in paragraph 3 of this Annex.

2.2.2. For all other tyres the test procedure is as shown in Appendix 1 to this Annex.

2.3. Endurance test programme — See also Appendix 1 to this Annex.

2.3.1. The tyre pressure shall not be corrected throughout the test and the test load shall be kept constant throughout each of the three test stages.

2.3.2. During the test the temperature of the test room shall be maintained at between 20 oC and 30 oC unless the tyre manufacturer or retreader agrees to the use of a higher temperature.

2.4. The endurance test programme shall be carried out without interruption.

3.

Load/speed test procedure for tyres with a load index ≤ 121 and a speed symbol ≥ Q (160 km/h):

3.1. The load on the wheel and tyre shall be the following percentage of that corresponding to the load index of the tyre:

3.1.1. 90 % when tested on a drum of 1,70 m ± 1 % diameter;

3.1.2. 92 % when tested on a drum of 2,00 m ± 1 % diameter.

3.2. The initial phase test speed shall be 20 km/h less than that indicated by the speed symbol for the tyre.

3.2.1. Time taken to reach initial test speed shall be 10 minutes.

3.2.2. The duration of the first phase shall be 10 minutes.

3.3. The second phase test speed shall be 10 km/h less than that indicated by the speed symbol for the tyre.

3.3.1. The duration of the second phase shall be 10 minutes.

3.4. The final phase test speed shall be the speed corresponding to that indicated by the speed symbol for the tyre.

3.4.1. The duration of the final phase shall be 30 minutes.

3.5. The duration of the entire test shall be 1 hour.

4.

Equivalent test method:

If a test method other than that given in paragraphs 2 or 3 of this Annex is used, its equivalence must be demonstrated.