Annex VII to Delegated Regulation (EU) 2017/79 is amended as follows:
point 1.3.1. is replaced by the following:
‘1.3.1. The manufacturer shall provide the technical service and the type-approval authority with documentation in accordance with the Table, which shall contain for each item the technical principle applied to monitor the item.’;
in the Table, the third row (the second item) is replaced by the following:
‘Mobile network antenna is connected’ |
in the Table, the fifth row (the fourth item) is replaced by the following:
‘GNSS antenna is connected’ |
point 2.1.1. is replaced by the following:
‘2.1.1. The following test shall be performed, separately for each of the items listed in the Table, on the vehicle with an eCall in-vehicle system installed in accordance with Article 5, on the STU in accordance with Article 7 or on the component, that is made part of a complete system for the purpose of the test, in accordance with Article 6.’;
point 2.1.2. is replaced by the following:
‘2.1.2. Simulate a malfunction of the eCall system by introducing a critical failure monitored by the self-test function according to the technical documentation provided by the manufacturer. The manufacturer shall provide a list of the checks and a description of how to trigger them.’;
in point 2.1.5., the following sentence is added:
‘For the failures which cannot be simulated or injected by the technical service, the manufactures shall provide a documentation describing the test procedure and the test results to the technical service.’;
point 3.1. is replaced by the following:
‘3.1. When the manufacturer submits an application for revision or extension of an existing type-approval for the purpose of including an alternative GNSS antenna, electronic control unit, mobile network antenna and/or power source components, no retesting of 112-based eCall in-vehicle system components shall be required for the purpose of fulfilling the requirements of this Annex, provided that those type-approved components possess at least the same functional features and that they are covered by this Annex in accordance with Article 6(3).’;
the following point 4 is added:
The purpose shall be to verify the following features of the eCall system:
its correct operational status, by visual observation of the failure warning signal status following the activation of the vehicle master control switch and any bulb check. Where the failure warning signal is only displayed in a common space (the area on which two or more information functions or symbols may be displayed, but not simultaneously), it must be checked first that the common space is functional prior to the failure warning signal status check;
the correct accuracy of the Minimum Set of Data (by generating and reading current MSD), the correct function and condition of the eCall components and the backup-battery (if applicable), by the use of an electronic vehicle interface;
the software integrity, by external verification of version information, hash values and system configurations against reference data;
the correct functionality of the voice communication, by performing an audio echo and speaker test using the vehicle interface.
4.2.1. The 112-based eCall in-vehicle system shall be able to provide the information to perform the methods of testing specified in Section 3, point 7.13, of Annex I to Directive 2014/45/EU using the electronic vehicle interface.
4.2.2. The manufacturer shall make available the technical information, which shall contain the instructions for reading out the information or performing the checks related to each item specified in Section 3, point 7.13, of Annex I to Directive 2014/45/EU.
4.3.1. It shall be verified that the information related to each item specified in Section 3, point 7.13 of Annex I to Directive 2014/45/EU, can be read out from the eCall system using the electronic vehicle interface according to the instructions of the manufacturer.
4.3.2. It shall be verified that an echo and speaker test can be performed to check the correct functionality of the voice communication via the vehicle interface.’.