ANNEX V EU type-approval mark of components and separate technical units, Regulation (EU) 2020/683

In forcesince 28 Jul 2022cited 1×
1.

The EU type-approval mark for components and separate technical units referred to in Article 38(2) of Regulation (EU) 2018/858 shall consist of:

1.1. A rectangle surrounding the lower-case letter ‘e’, followed by the distinguishing number of the Member State which has granted the type-approval for the component or separate technical unit:

1 for Germany; | 19 for Romania;

2 for France; | 20 for Poland;

3 for Italy; | 21 for Portugal;

4 for the Netherlands; | 23 for Greece;

5 for Sweden; | 24 for Ireland;

6 for Belgium; | 25 for Croatia;

7 for Hungary; | 26 for Slovenia;

8 for the Czech Republic; | 27 for Slovakia;

9 for Spain; | 29 for Estonia;

11 for the United Kingdom; | 32 for Latvia;

12 for Austria; | 34 for Bulgaria;

13 for Luxembourg; | 36 for Lithuania;

17 for Finland; | 49 for Cyprus;

18 for Denmark; | 50 for Malta.

1.2. In the vicinity of the rectangle, two digits indicating the series of amendments laying down the requirements with which this component or separate technical units complies, followed by a space and the five-digit number referred to in point 2.4 of Annex IV.

1.3. An additional symbol or symbols located above the rectangle where required by the regulatory act laying down the applicable requirements.

2.

The type-approval mark of components or separate technical units shall be indelible and clearly legible.

3.

Example of a type-approval mark for a fourth type-approval of a component granted by Belgium. 01 denotes the series of amendments of the Regulation laying down the applicable requirements with which this component complies.

4.

This Annex does not apply to type-approvals granted in accordance with the UN Regulations listed in Annex II to Regulation (EU) 2018/858.

However, this Annex applies to EU type-approvals of components and separate technical units granted in accordance with Regulation (EU) 2019/2144 on the basis of the requirements laid down in the UN Regulations listed in Annex I to that Regulation, in which case the following shall apply:

(a)

the distinguishing type-approval marking shall be as prescribed in the applicable UN Regulation;

(b)

where the applicable UN Regulation requires a circle surrounding the letter ‘E’ to be part of the type-approval mark, a rectangle rather than a circle shall be used. The height of the rectangle shall correspond to at least the prescribed diameter of the circle and its width shall exceed that value. Instead of the upper-case letter ‘E’, the lower-case letter ‘e’ shall be used, followed by the distinguishing number of the Member State which has granted the EU type approval of the component or separate technical unit.

Example of a type-approval mark for a type-approval granted by Germany, on the basis of requirements laid down in the UN Regulation 28 (127) of the Economic Commission for Europe of the United Nations (UN/ECE), on uniform provisions concerning the approval of audible warning devices and of motor vehicles with regard to their audible signals, listed in Annex II to Regulation (EU) 2018/858, original series, first approval issued, for a Class II audible warning device incorporating new technologies: