For each of the regulatory acts listed in Part I of Annex II to Regulation (EU) 2018/858, the test report referred to in Article 30(2) of Regulation (EU) 2018/858 shall comply with the Standard EN ISO/IEC 17025:2017 (152). It shall in particular include the information referred to in point 7.8.2 of that standard.
The test report shall be issued in one of the official languages of the Union determined by the type-approval authority.
The test report shall include at least the following information:
the identification of the vehicle, system, component or separate technical unit tested;
a detailed description of the, vehicle, system, component or separate technical unit characteristics required by the applicable regulatory act listed in Annex II to Regulation (EU) 2018/858;
the results of the measurements required by the applicable regulatory act;
with regard to each measurement mentioned in point 3(c), whether the limit or threshold laid down by the applicable regulatory act has been met;
when other test methods than those prescribed in the applicable regulatory acts are permitted and used, the report shall include a description of those test methods;
pictures taken during testing, the number of which shall be decided by the approval authority. In the case of virtual testing, screen prints or other suitable evidence may replace pictures;
overall test conclusions that describes that the system, component or separate technical unit in the test report is in compliance with all the requirements of the applicable regulatory act listed in Annex II to Regulation (EU) 2018/858 and that the tested system, component or separate technical unit was representative in terms of the type to be approved;
opinions and interpretations shall be documented properly and marked as such in the test report.
Where the manufacturer and the type-approval authority or technical service have reached an agreement on a worst-case configuration, testing of that configuration alone shall be sufficient. The test report shall include the information how the worst-case configuration of the system, component or separate technical unit has been determined.
If a format of a test report is provided in the respective Regulatory act listed in Part I of Annex II to Regulation (EU) 2018/858 that model shall be used.