ANNEX C MONTHLY ENERGY STATISTICS, Regulation (EU) 2019/2146

In forcesince 26 Nov 2019

This Annex describes the scope, units, reported period, frequency, deadline and transmission modalities for the monthly collection of energy statistics.

Explanations of terms for which a specific explanation is not supplied in this Annex can be found in Annex A.

The following provisions apply to all data collections specified in this Annex:

(a)

Reported period: The reported period of declared data shall be one calendar month.

(b)

Frequency: Data shall be declared on a monthly basis.

(c)

Transmission format: The transmission format shall conform to the relevant interchange standard specified by Eurostat.

(d)

Transmission method: Data shall be submitted or uploaded by electronic means to the single entry point for data at Eurostat.

This chapter covers the reporting of:

These are the quantities held by mines, importers and consumers who import directly.

These are the quantities held by mines, importers and consumers who import directly.

These are the quantities held by mines, importers and consumers who import directly.

These are the quantities held by mines, importers and consumers who import directly.

These are the quantities held by producers, importers and consumers who import directly.

These are the quantities held by producers, importers and consumers who import directly.

Reported quantities must be declared in kt (kilo-tonnes).

Within two calendar months following the reported month.

This chapter covers the reporting of electricity.

The following aggregates shall be declared for electricity:

Reported quantities must be declared in GWh (giga-watt hours).

Within two calendar months following the reported month.

Unless otherwise specified, this data collection applies to all energy products listed in Annex A, Chapter 3.4. Oil (crude oil and petroleum products).

The ‘Other Products’ category includes both the quantities that correspond to the definition in Annex A Chapter 3.4 and also the quantities of white spirit and SBP, lubricants, bitumen and paraffin waxes; these products should not be declared separately.

The following aggregates shall be declared for all energy products listed in the previous paragraph unless otherwise specified.

Note for additives and biofuels: include here not only already blended volumes, but also all quantities destined for blending.

The following aggregates shall be declared for crude oil, NGL, refinery feedstocks, additives/oxygenates, biofuels and other hydrocarbons:

Finished or semi-finished products which are returned from final consumers to refineries for processing, blending or sale. They are usually by-products of petrochemical manufacturing. Only applicable for refinery feedstocks.

Imported petroleum products which are reclassified as feedstocks for further processing in the refinery, without delivery to final consumers. Only applicable for refinery feedstocks.

Note for import and exports: Includes quantities of crude oil and products imported or exported under processing agreements (i.e. refining on account). Crude oil and NGLs should be reported as coming from the country of ultimate origin; refinery feedstocks and finished products should be reported as coming from the country of last consignment. Includes any gas liquids (e.g. LPG) extracted during the regasification of imported liquefied natural gas and petroleum products imported or exported directly by the petrochemical industry.

A stock build is shown as a positive number and a stock draw is shown as a negative number.

This is defined as the total amount of oil (including Other hydrocarbons and Additives) observed to have entered the refinery process (input to refineries).

The difference between observed refinery intake and gross refinery output. Losses may occur during distillation processes due to evaporation. Reported losses are positive. There may be volumetric gains but no gains in mass.

The following aggregates shall be declared for Crude oil, NGL, Refinery gas, Ethane, LPG, Naphtha, Biogasoline, Non-biogasoline, Aviation gasoline, Gasoline type jet fuel, Bio jet kerosene, Non-bio jet Kerosene, Other kerosene, Biodiesels, Non-bio gas/diesel oil, LSFO, HSFO, Petroleum coke, and Other products:

Annex A Chapter 2.3. Energy sector — Petroleum Refineries; Includes fuels used at the refineries for the production of electricity and heat sold.

The note made for imports and exports in section 3.2.1 also applies here.

A stock build is shown as a positive number and a stock draw is shown as a negative number.

The observed delivery of finished petroleum products from primary sources (e.g. refineries, blending plants, etc.) to the inland market.

Imports shall be reported by country of origin and exports by country of destination. The note made for imports and exports in section 3.2.1 also applies here.

The following opening and closing stocks must be declared for all energy products, including for additives/oxygenates but except for refinery gas:

Stocks in the following locations: refinery tanks, bulk terminals, pipeline tankage, barges and coastal tankers (when port of departure and destination are in the same country), tankers in a port of a member country (if their cargo is to be discharged at the port), inland ship bunkers. Excludes stocks of oil held in pipelines, in rail tanks cars, in truck tanks cars, in sea-going ships’ bunkers, in service stations, in retail stores and in bunkers at sea.

Stocks on national territory which belong to another country and to which access is guaranteed by an agreement between the respective governments.

Stocks not included in point 3.2.4.2 on national territory which belong to and are destined for another country. These stocks may be located inside or outside bonded areas.

Includes stocks not included in point 3.2.4.2 nor 3.2.4.3 irrespective of whether they have received customs clearance or not.

Include stocks which are subject to government control. This definition does not include other consumer stocks.

Stocks irrespective of whether they have been cleared by customs or not. This category excludes stocks on board vessels at high seas.

Includes oil in coastal tankers if both their port of departure and destination are in the same country. In the case of incoming vessels with more than one port of unloading, only report the amount to be unloaded in the reporting country.

Includes non-military stocks that are held by the government within the national territory, and are government owned or controlled and held exclusively for emergency purposes.

Excludes stocks held by state oil companies or electric utilities or stocks held directly by oil companies on behalf of governments.

Stocks held by both public and private corporations established to maintain stocks exclusively for emergency purposes.

Excludes mandatory stocks held by private companies.

All other stocks satisfying the conditions described in point 3.2.4.1 above.

Stocks belonging to the reporting country but held in another country, to which access is guaranteed by an agreement between the respective governments.

Stocks that are not included in category 10 and that belong to the reporting state but are held in another state and are awaiting import there.

Other stocks in the national territory not included in the above categories.

Oil (crude oil and petroleum products) contained in pipelines, necessary to maintain flow in the pipelines.

In addition, a breakdown of quantities per corresponding country must be declared for:

‘Opening stocks’ means the stocks on the last day of the month preceding the reported one. ‘Closing stocks’ means the stocks on the last day of the reported month.

Reported quantities must be declared in kt (kilo-tonnes).

Within 55 days following the reported month.

For statistical reporting purposes only, the clarifications in Annex A Chapter 1 apply with the following specific exception: Switzerland includes Liechtenstein

This chapter covers the reporting of natural gas.

The following aggregates shall be declared for natural gas.

All dry marketable production within national boundaries, including offshore production. Production is measured after purification and extraction of NGLs and sulphur. Excludes extraction losses and quantities reinjected, vented or flared. Includes quantities used within the natural gas industry, in gas extraction, pipeline systems and processing plants.

Note for imports and exports: Report all natural gas volumes which have physically crossed the national boundaries of the country, whether customs clearance has taken place or not. This includes quantities transiting your country; transit volumes should be included as an import and as an export. Imports of liquefied natural gas should cover only the dry marketable equivalent, including amounts used as own consumption in the regasification process. The amounts used as own consumption during regasification should be reported under Own use and losses of the natural gas industry (see 4.2.10). Any gas liquids (e.g. LPG) extracted during the regasification process of imported LNG should be reported under ‘Receipts from other sources’ of ‘Other hydrocarbons’ as defined in Chapter 3 of this annex (OIL AND PETROLEUM PRODUCTS).

A stock build is shown as a positive number and a stock draw is shown as a negative number.

This category represents deliveries of marketable gas to the inland market, including gas used by the gas industry for heating and operation of their equipment (i.e. consumption in gas extraction, in the pipeline system and in processing plants); losses in transmission and distribution should also be included.

Note for levels of stocks: includes natural gas stored in gaseous form as well as in liquefied form.

Quantities used by the gas industry for heating and operation of its equipment (i.e. consumption in gas extraction, in the pipeline system and in processing plants); includes losses in transmission and distribution.

Imports (entries) shall be reported by country of origin and exports (exits) by country of destination. The note made for imports and exports in section 4.2.3 also applies here. Imports and exports are to be declared only for the neighbouring country or country with a direct pipeline connection or, in the case of LNG, for the country where the gas has been loaded onto the transport ship.

Quantities must be declared in two units:

4.3.1. in physical quantity, in million m3 (million cubic metres) assuming reference gas conditions (15 °C, 101325 Pa),

4.3.2. in energy content, in TJ (tera-joules), based on the gross calorific value.

Within 55 days following the reported month.