ANNEX IV, Regulation (EU) 2016/1718

In forcesince 20 Sep 2016

Annex XI to Regulation (EU) No 582/2011 is amended as follows:

(1)

point 4.3.2.4 is replaced by the following:

The exhaust after-treatment system tested in accordance with point 4.3.2.2 and incorporating the replacement pollution control device shall be subjected to the durability procedures described in Appendix 3.’;

(2)

the following point 4.3.5 is inserted:

In the case described in point 1.1.2 of Annex I, the test procedure laid down in points 4.3.1 to 4.3.2.7 of this Annex shall be conducted with the fuels declared by the manufacturer of the original engine system. However, in agreement with the type-approval authority, the durability procedure set out in Appendix 3 and referred to in point 4.3.2.4 may be performed only with the fuel which represents the worst case in terms of ageing.’;

(3)

the following points 4.6 to 4.6.5 are inserted:

4.6.1.

NOx control measures compatibility demonstration is required only when the original pollution control device was monitored in the original configuration.

4.6.2.

The compatibility of the replacement pollution control device with the NOx control measures shall be demonstrated by using the procedures described in Annex XIII to this Regulation, for replacement pollution control devices intended to be fitted to engines or vehicles type-approved in accordance with Regulation (EC) No 595/2009 and this Regulation.

4.6.3.

The provisions in UN/ECE Regulation No 49 applicable to components other than pollution control devices shall not apply.

4.6.4.

The replacement pollution control device manufacturer may use the same preconditioning and test procedure as used during the original type-approval. In that case, the approval authority which granted original type-approval of an engine of a vehicle shall provide, on request and on a non-discriminatory basis, an information document presented as an appendix to the Information Document provided for in Appendix 4 to Annex I, which contains the number and type of preconditioning cycles and the type of test cycle used by the original equipment manufacturer for NOx control measures testing of the pollution control device.

4.6.5.

Point 4.5.5 shall apply to NOx control measures monitored by the OBD system.’;

(4)

Appendix 3 is replaced by the following:

(5)

the following Appendices 4 to 8 are added:

‘’

.