Art. 13 Directive (EU) 2014/31

Conformity assessment procedures

In forcesince 26 Feb 2014cited 2×
1.

The conformity of instruments to the essential requirements set out in Annex I may be established by either of the following conformity assessment procedures as selected by the manufacturer:

(a)

Module B as set out in point 1 of Annex II, followed either by Module D as set out in point 2 of Annex II, or by Module F as set out in point 4 of Annex II.

However, Module B shall not be compulsory for instruments which do not use electronic devices and the load-measuring device of which does not use a spring to balance the load. For those instruments not submitted to Module B, Module D1 as set out in point 3 of Annex II or Module F1 as set out in point 5 of Annex II shall apply;

(b)

Module G as set out in point 6 of Annex II.

2.

The documents and correspondence relating to the conformity assessment procedures referred to in paragraph 1 shall be drawn up in one of the official languages of the Member State where those procedures are carried out, or in a language accepted by the body notified in accordance with Article 19.

  • Opinion of Advocate General Biondi delivered on 7 May 2026. Land Nordrhein-Westfalen v Bizerba.Decision

    In the event that an instrument is not fully in conformity with a harmonised standard, conformity may be established by one of the assessment procedures provided for in Article 13 of Directive 2014/31.

    7 May 2026 · 62025CC0238

  • BVerwG, EuGH-Vorlage vom 16. Oktober 2024 - 8 C 7/22Decision

    … Diese Konformitätsvermutung besteht nach Art. 12 und 13 Richtlinie 2014/31/EU zwar nur mit den wesentlichen Anforderungen gemäß Anhang I der Richtlinie. Die vorliegend streitigen Regelungen der Richtlinie finden sich jedoch in ihrem …

    16 Oct 2024 · WBRE202500219