Art. 19 Directive (EU) 2013/53

Applicable conformity assessment procedures

In forcecited 3×
1.

The manufacturer shall apply the procedures set out in the modules referred to in Articles 20, 21 and 22 before placing on the market products referred to in Article 2(1).

2.

The private importer shall apply the procedure referred to in Article 23 before putting into service a product referred to in Article 2(1) if the manufacturer has not carried out the conformity assessment for the product concerned.

3.

Any person placing on the market or putting into service a propulsion engine or a watercraft after a major modification or conversion thereof, or any person changing the intended purpose of a watercraft not covered by this Directive in a way that it falls under its scope, shall apply the procedure referred to in Article 23 before placing the product on the market or putting it into service.

4.

Any person placing on the market a watercraft built for own use before the end of the five-year period referred to in point (vii) of point (a) of Article 2(2) shall apply the procedure referred to in Article 23 before placing the product on the market.

  • The Product Safety and Metrology etc. (Amendment etc.) (EU Exit) Regulations 20194562Law

    … of conformity No xxxxx) is amended as follows— (a) in the heading omit “EU”; (b) in paragraph 3 for “Article 19(3) or (4) of Directive 2013/53/EU” substitute “ regulation 43(2) or (3) of the Recreational Craft Regulations 2017 …

  • The Recreational Craft Regulations 2017Law

    … is issued under the sole responsibility of the manufacturer or the private importer or the person referred to in Article 19(3) or (4) of Directive 2013/53/EUregulation 43(2) or (3) of the Recreational Craft Regulations 2017 (S.I. 2017/737, …

  • Regulation (EU) 2017/18Law

    1. При посоченото в членове 19 и 23 от Директива 2013/53/ЕС оценяване на етапа след построяването, когато нотифицираният орган трябва да …