Art. 6 Commission Regulation (EU) No 582/2011 of 25 May 2011 implementing and amending Regulati…

Administrative provisions for EU type-approval of an engine system or engine family as a separate technical unit with regard to emissions

In forcesince 12 Mar 2026cited 4×
1.

If all the relevant requirements are met, the approval authority shall grant an EU type-approval of an engine system or engine family as a separate technical unit and issue a type-approval number in accordance with the numbering system set out in the applicable implementing act adopted pursuant to Article 28(3) of Regulation (EU) 2018/858 of the European Parliament and of the Council [Regulation (EU) 2018/858 of the European Parliament and of the Council of 30 May 2018 on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles, amending Regulations (EC) No 715/2007 and (EC) No 595/2009 and repealing Directive 2007/46/EC (OJ L 151, 14.6.2018, p. 1)].

Without prejudice to the provisions of that implementing act, Section 3 of the type-approval number shall be drawn up in accordance with Appendix 9 to Annex I to this Regulation.

An approval authority shall not assign the same number to another engine type.

1a.

As an alternative to the procedure provided for in paragraph 1, the approval authority shall grant an EC type-approval of an engine system or engine family as a separate technical unit if all the following conditions are fulfilled:

(a)

a type-approval of an engine system or engine family as separate technical unit has already been granted in accordance with UNECE Regulation No 49 at the moment of the application for EC type-approval;

(b)

the requirements set out in Articles 2a to 2f of this Regulation on access to vehicle OBD and vehicle repair and maintenance information and applicable to the engine system or engine family are met;

(c)

the requirements set out in point 6.2 of Annex X to this Regulation are met during the transitional period specified in Article 4(7);

(d)

all other exceptions set out in points 3.1 and 5.1 of Annex VII to this Regulation, points 2.1 and 6.1 of Annex X to this Regulation, points 2, 4.1, 5.1, 7.1, 8.1 and 10 of Annex XIII to this Regulation, and point 1 of Appendix 6 to Annex XIII to this Regulation apply;

(e)

the requirements set out in Article 2 of Implementing Regulation (EU) 2025/2161 are met, except where the manufacturer indicated in the declaration of compliance set out in point 6.1 of Annex I to that Implementing Regulation that new engines of the type to be approved will not be registered, sold or put into service in the Union on or after the relevant date set out in Table 1 of Annex I to that Implementing Regulation.

2.

When granting an EC type-approval under paragraphs 1 and 1a, the approval authority shall issue an EC type-approval certificate using the model set out in Appendix 5 to Annex I.