Art. 10 Commission Regulation (EU) No 10/2011 of 14 January 2011 on plastic materials and articl…

General restrictions and requirements concerning the composition of plastic materials and articles

In forcesince 16 Mar 2025cited 5×
1.

Plastic materials and articles shall meet the restrictions on plastic materials and articles laid down in Annex II.

2.

Plastic materials and articles may contain reprocessed plastic if such reprocessed plastic meets the following conditions:

(a)

it is a by-product in accordance with Article 5 of Directive 2008/98/EC of the European Parliament and of the Council [Directive 2008/98/EC of the European Parliament and of the Council of 19 November 2008 on waste and repealing certain Directives (OJ L 312, 22.11.2008, p. 3, ELI: http://data.europa.eu/eli/dir/2008/98/oj).];

(b)

it is collected and used in accordance with section C of the Annex to Regulation (EC) No 2023/2006;

(c)

it originates from one of the following off-cuts and scraps from plastic materials and articles:

(i)

off-cuts and scraps from plastic materials and articles referred to in point (a) of Article 2(1) that meet the compositional requirements set out in Chapter II of this Regulation, or

(ii)

off-cuts and scraps from plastic materials and articles referred to points (b) and (c) of Article 2(1), provided that such reprocessed plastic does not contain a layer which functions as a functional barrier and all of its individual constituents either meet the compositional requirements set out in Chapter II of this Regulation, or have been subject to risk assessment on the basis of Article 19 taking into account the conditions of reprocessing and their presence in the reprocessed material;

(d)

it does not contain substances in an amount which could:

(i)

exceed migration limits applicable for the substance as specified in this Regulation; or

(ii)

cause any other non-compliance of those plastic materials and articles with Article 3 of Regulation (EC) No 1935/2004.

3.

Where intended for repeated use in contact with food, the composition and the design of final food contact articles shall be such, so as to guarantee that no increase in the migration of constituents of the material or article to the food would occur when subjected to subsequent use cycles of the articles in accordance with the instructions for intended use as described in documentation or labelling.

  • Commission Regulation (EC) No 2023/2006 of 22 December 2006 on good manufacturing practi…Law

    … които са предназначени за повторна преработка в съответствие с член 10, параграф 2 от Регламент (ЕС) № 10/2011 („материали, …

  • Regulation (EU) 2025/351Lawamends

    … des procédés de fabrication de matière plastique qui sont destinés à être retransformés conformément à l’article 10, paragraphe 2, du règlement (UE) no 10/2011 (ci-après les “matériaux destinés à la retransformation”) …

  • Bedarfsgegenständeverordnung8Law

    … den Bedarfsgegenständen auf Lebensmittel übergehen, die dort angegebenen Höchstmengen nicht überschreiten. (4) Die Artikel 10, 11, 12, 17 und 18 der Verordnung (EU) Nr. 10/2011 gelten für Lebensmittelbedarfsgegenstände im Sinne des …

  • Regulation (EU) 2020/1245Law

    Genom artikel 10 i förordning (EU) nr 10/2011 fastställs allmänna begränsningar för material och produkter av plast i bilaga II till den förordningen. I punkt 1 i denna bilaga begränsas migration av vissa grundämnen från material …

  • Bedarfsgegenständeverordnung8Law