Art. 12 Directive (EU) 2006/42

Procedures for assessing the conformity of machinery

In forcecited 4×
1.

The manufacturer or his authorised representative shall, in order to certify the conformity of machinery with the provisions of this Directive, apply one of the procedures for assessment of conformity described in paragraphs 2, 3 and 4.

2.

Where the machinery is not referred to in Annex IV, the manufacturer or his authorised representative shall apply the procedure for assessment of conformity with internal checks on the manufacture of machinery provided for in Annex VIII.

3.

Where the machinery is referred to in Annex IV and manufactured in accordance with the harmonised standards referred to in Article 7(2), and provided that those standards cover all of the relevant essential health and safety requirements, the manufacturer or his authorised representative shall apply one of the following procedures:

(a)

the procedure for assessment of conformity with internal checks on the manufacture of machinery, provided for in Annex VIII;

(b)

the EC type-examination procedure provided for in Annex IX, plus the internal checks on the manufacture of machinery provided for in Annex VIII, point 3;

(c)

the full quality assurance procedure provided for in Annex X.

4.

Where the machinery is referred to in Annex IV and has not been manufactured in accordance with the harmonised standards referred to in Article 7(2), or only partly in accordance with such standards, or if the harmonised standards do not cover all the relevant essential health and safety requirements or if no harmonised standards exist for the machinery in question, the manufacturer or his authorised representative shall apply one of the following procedures:

(a)

the EC type-examination procedure provided for in Annex IX, plus the internal checks on the manufacture of machinery provided for in Annex VIII, point 3;

(b)

the full quality assurance procedure provided for in Annex X.

  • Regulation (EU) 2023/123052Law

    … на типа и решенията за одобрение, издадени в съответствие с член 12 от Директива 2006/42/ЕО, остават валидни до изтичане на срока им на …

  • Judgment of the General Court (Second Chamber) of 26 January 2017. Global Garden Products Italy SpA (GGP Italy) v European Commission.Decision

    As regards, next, the substantive examination of the plea in law, it should be noted, first of all, that the reference to a harmonised standard is only one of the possibilities available to a manufacturer to show that his machinery …

    26 Jan 2017 · 62015TJ0474

  • Opinion of Advocate General Spielmann delivered on 11 September 2025. Dürr Dental SE v Cattani Deutschland Helmes GmbH & Co. KG.Decision

    Article 5 of that directive provides in addition that, before placing machinery on the market and/or putting it into service, the manufacturer has a number of obligations, including the obligations to provide the necessary information, …

    11 Sep 2025 · 62024CC0010

  • Arrêt du Tribunal (troisième chambre) du 3 mai 2018. Grizzly Tools GmbH & Co.KG contre Commission européenne.Decision

    Il y a lieu de rappeler, deuxièmement, que le PHD 100 B2 fait partie des machines non visées à l’annexe IV de la directive 2006/42, de sorte que la requérante devait appliquer, avant sa mise sur le marché et conformément à …

    3 May 2018 · 62016TJ0168