, Communication from the Commission relating to the characteristics of products to be supp…

In force
–

appearance: white or slightly yellow, no impurities or coloured particles,

–

antimicrobial substances: negative.

2.

Vitaminised skimmed-milk powder

Vitaminised skimmed-milk powder obtained by the spray method and meeting the requirements set out at E.1 and also the following:

–

vitamin A content in IU/100 gram: 5000-10000,

–

vitamin D content in IU/100 gram: 500-1000.

The vitamin mixture incorporated in the milk must be guaranteed to contain 10 times more vitamin A than vitamin D. The vitamins must be of pharmaceutical quality and produced for human consumption. The vitamin A must be in the form of palmitate and/or acetate. The 10:1 ratio between the vitamin A and vitamin D concentration and also the content of these vitamins in the preparation to be added to the skimmed-milk powder shall be guaranteed by the producer and/or supplier in writing. Only products meeting these requirements may be added to the skimmed-milk powder to enrich it with vitamins A and D.

The information on the preparation of the vitamins A and D used allowing identification of:

–

entries, removals and quantities used,

–

the name and address of the producer and/or supplier,

–

the enrichment procedure used,

–

the "use-by" date,

must be entered in a register that the manufacturer of the vitaminised skimmed-milk powder shall be obliged to keep. The register shall be available to the Commission or its representative (monitor) for consultation.

The reference method for determination of vitamin A content is that given in international standard FIL 142. That for determining the vitamin D content of the preparation to be added to the skimmed-milk powder is the one given in AOAC Methods 43.079.

3.

Semi-skimmed-milk powder

Semi-skimmed-milk powder obtained by the spray method and meeting the requirements set out at E.1 with the following changes:

–

fat: 12-15 %,

–

moisture: maximum 3 %.

4.

Whole-milk powder

Extra grade whole-milk powder obtained by the spray method and meeting the following requirements:

–

fat: minimum 26 %,

–

moisture: maximum 3 %,

–

titratable acidity (of non-fat dry matter) ADPI:

–

in ml of decinormal sodium hydroxide solution: maximum 3,

–

in lactic acid: maximum 0,15 %,

–

lactates (in non-fat dry matter): maximum 150 mg/100 g,

–

additives: none,

–

phosphatase test: negative, i.e. maximum 4 μg of phenol/g of reconstituted milk,

–

insolubility index: maximum 0,5 ml (at 24 °C),

–

burnt particles: maximum 15 mg, i.e. at least disc B,

–

micro-organisms: maximum 50000/g,

  • celex=31996R1080
  • celex=31996R1854