The investigation has established that of the eight companies identified in recital 5 above four assemblers ordered almost complete bicycles in a disassembled form from the producers in China during the investigation period. For the corresponding shipments to Europe the suppliers ensured that parts destined for the same assembler were spread across different containers, sent on different dates and sometimes unloaded at different ports. By this practice, which is rather costly and implies important additional logistical constraints, the assemblers avoided classification of the imported parts, in accordance with Rule 2 (a) of the general rules for the interpretation of the nomenclature of the common customs tariff (hereafter CCT), as finished bicycles which would have been subject to the anti-dumping duty.
One of the companies mentioned in recital 5 applied the above described modus operandi for about 75 % of its total assembly of bicycles during the investigation period. However, during that period it changed its sourcing pattern and towards the end of that period it started to assemble these bicycles by using more than 40 % of non-Chinese parts, which it purchased either directly from manufacturers located in the countries of origin or from subsidiaries of these manufacturers located in the Community (see recital 17).
In order to ensure that certain imported sub-assemblies of bicycle parts would not be classified in accordance with Rule 3 (b) of the general rules for the interpretation of the nomenclature of the CCT as finished bicycles, some assemblers have asked for and received from national customs authorities binding tariff information classifying these assemblies as parts and thus obtaining official assurance that the anti-dumping duty would not be applied to these sub-assemblies.
Conditions of Article 13
Change in the pattern of trade