Recital 31, Decision_act (EU) 1995/421

In forcesince 21 Dec 1994

Electrical sheet must be further differentiated as between oriented material and non-oriented material. On the demand side, there are differences between the application areas of both types of product. Oriented material has good conductivity, low core loss and lesser heat development, whereas non-oriented material is characterized by higher resistance and higher heat development.

Oriented and non-oriented material must also be distinguished according to the method of production. Both kinds of material are pickled and cold rolled, but they undergo a different annealing process, this being the process by which material acquires the required electromagnetic properties. Since the necessary production facilities differ considerably, there is no supply-side substitutability. There are therefore two separate markets for oriented and non-oriented electrical sheet.

TRADE IN STAINLESS STEEL (32) As already indicated, distribution has to be considered a separate market as far as stainless steel is concerned. Of West European stainless steel production, an estimated 30 P40 % (the figures vary slightly between the various competitors) is sold through stockholders or service centres. Electrical sheet is mainly sold direct to the customer and virtually none is dealt in by stockholders or service centres. Eletrical sheet is mainly sold direct to the customer and virtually none is dealt in by stockholders or service centres.