For the purposes of applying this Chapter and the TBT Agreement, standards issued by international organisations such as the International Organisation for Standardisation (ISO), the International Electrotechnical Commission (IEC), the International Telecommunication Union (ITU), the Codex Alimentarius Commission, the International Civil Aviation Organisation (ICAO), the World Forum for Harmonisation of Vehicle Regulations (WP.29) within the framework of the United Nations Economic Commission for Europe (UNECE), the United Nations Sub-Committee of Experts on the Globally Harmonized System of Classification and Labelling of Chemicals (UNSCEGHS), and the International Council for Harmonisation of Technical Requirements for Pharmaceuticals for Human Use (ICH) shall be considered as relevant international standards as referred to in this Chapter, Articles 2 and 5 of the TBT Agreement and Annex 3 to the TBT Agreement, provided that in their development, the principles and procedures set out in the Decision of the WTO Committee on Technical Barriers to Trade on Principles for the Development of International Standards, Guides and Recommendations with Relation to Articles 2 and 5 of the TBT Agreement and Annex 3 to the TBT Agreement [Annex 4 to WTO Document G/TBT/9, dated 13 November 2000.] have been followed, except when such standards or relevant parts of them would be ineffective or inappropriate for the fulfilment of the legitimate objectives pursued.
With a view to harmonising standards on as wide a basis as possible, the Parties shall encourage regional or national standardising bodies within their territories to:
play a full part, within the limits of their resources, in the preparation by relevant international standardising bodies of international standards;
use relevant international standards as a basis for the standards they develop, except where such international standards would be ineffective or inappropriate, for instance because of an insufficient level of protection or fundamental climatic or geographical factors or fundamental technological problems;
avoid duplication of, or overlap with, the work of international standardising bodies; and
review their standards which are not based on relevant international standards at appropriate intervals, preferably not exceeding five years, with a view to increasing their convergence with relevant international standards.
When developing technical regulations or conformity assessment procedures:
each Party shall use relevant international standards, guides or recommendations, or the relevant parts of them, to the extent provided for in paragraph 4 of Article 2 and in paragraph 4 of Article 5 of the TBT Agreement, as a basis for its technical regulations and conformity assessment procedures and avoid deviations from the relevant international standards or additional requirements when compared to those standards, except when the Party developing the technical regulation or conformity assessment procedure can demonstrate, based on relevant information, including available scientific or technical evidence, that such international standards would be ineffective or inappropriate for the fulfilment of legitimate objectives pursued, as referred to in paragraph 2 of Article 2 and paragraph 4 of Article 5 of the TBT Agreement; and
if a Party does not use relevant international standards, guides or recommendations, or the relevant parts of them, as referred to in paragraph 1, as a basis for its technical regulations or conformity assessment procedures, that Party shall, on request of the other Party, explain the reasons why it considers such international standards to be ineffective or inappropriate for the fulfilment of legitimate objectives pursued, as referred to in paragraph 2 of Article 2 and paragraph 4 of Article 5 of the TBT Agreement, and provide the relevant information, including available scientific or technical evidence on which this assessment is based, as well as identify the parts of the technical regulation or conformity assessment procedure concerned which in substance deviate from the relevant international standards, guides or recommendations.
Each Party shall encourage its regional or national standardising bodies within its territory to cooperate with the relevant standardising bodies of the other Party in international standardising activities. Such cooperation may take place in international standardising bodies of which both Parties or standardising bodies of both Parties are members. Such bilateral cooperation could aim, inter alia, at promoting the development of international standards, facilitating the development of common standards for both Parties in areas of shared interest where there are no international standards, in particular as regards new products or technologies, or further enhancing the exchange of information between the standardising bodies of the Parties.