Commission Regulation (EU) No 493/2012 of 11 June 2012 laying down, pursuant to Directiv…, 3

Calculation of recycling efficiency

In forcesince 31 Dec 2020
1.

The method set out in Annex I shall be used to calculate the recycling efficiency of a process for recycling waste lead-acid, nickel-cadmium and other batteries and accumulators.

2.

The method set out in Annex II shall be used to calculate the rate of recycled lead content for any recycling process.

3.

The method set out in Annex III shall be used to calculate the rate of recycled cadmium content for any recycling process.

4.

Recyclers shall report the information shown in Annex IV, Annex V and Annex VI, as applicable, on an annual basis and shall send it to the competent authority by no later than four months from the end of a calendar year concerned. Recyclers shall send their first annual reports no later than the 30 April 2015.

5.

Reporting on the recycling efficiency shall cover all individual steps of recycling and all corresponding output fractions.

6.

Where a recycling process is carried out at more than one facility, the first recycler is responsible for submitting the information required under point 4 to the competent authority.

Changed on 31 Dec 2020

4. Recyclers shall report the information shown in Annex IV, Annex V and Annex VI, as applicable, on an annual basis and shall send it to the Member State’s competent authoritiesauthority by no later than four months from the end of a calendar year concerned. Recyclers shall send their first annual reports no later than the 30 April 2015.

6. Where a recycling process is carried out at more than one facility, the first recycler is responsible for submitting the information required under point 4 to the Member State’s competent authoritiesauthority.

  1. 31 Dec 2020 – todayin force
  2. 11 Jun 2012 – 31 Dec 2020earlier wording