This control plan lays down the minimum conditions for the weighing of fresh fishery products after transport within the Member State of landing, in accordance with a derogation approved under Article 60(3)(c) of Regulation (EC) No 1224/2009.
This Annex shall only apply to fishery products weighed after transport in approved and registered weighing facilities, in accordance with the minimum requirements set out in section E of this Annex.
The Member State of landing shall ensure that transport units transporting fishery products covered by the derogation in Article 60(3)(c) of Regulation (EC) No 1224/2009 are readily identifiable throughout transport, from the place of loading to the place of destination of the consignment(s), where appropriate for control purposes.
The derogation to weigh under Article 60(3)(c) of Regulation (EC) No 1224/2009 shall be subject to the conditions set out in this Annex and other rules laid down in Articles 3 to 8 of this Regulation.
All fishery products transported in a transport unit for weighing after transport shall arrive in their entirety at a single weighing destination. By way of derogation, in the event of multiple loading locations of fish not previously weighed or multiple unloading locations to approved weighing facilities a separate transport document, including the information listed in point 9, shall be issued for each intermediary loading or unloading location before each transport.
Without prejudice to Article 24 of Commission Delegated Regulation (EU) 2025/1766 [Commission Delegated Regulation (EU) 2025/1766 of 27 August 2025 supplementing Council Regulation (EC) No 1224/2009 by laying down rules on the control of fisheries and on the surveillance and inspection of fishing activities, enforcement and compliance (OJ L, 2025/1766, 12.11.2025, ELI: http://data.europa.eu/eli/reg_del/2025/1766/oj).], and unless otherwise provided for under the rules of the CFP, transport units shall be sealed by the transporter using non-duplicatable tags issued by, or on behalf of, the competent authorities of the Member State of landing, where they are identified, on the basis of risk management taking into account at least the elements listed in Article 8(3) of this Regulation, as posing a high risk of non-compliance with the rules laid down in this Annex.
All fishery products transported to an authorised weighing facility under this Annex shall:
be distinguishable from catches already weighed and from catches of other vessels during transport from the place of landing to the weighing facility. The transport of catches from multiple vessels in a single transport unit is permitted only if clear separation of each vessels’ catch is ensured; and
arrive at the weighing facility in a condition that allows for species identification. For unsorted catches used for industrial purposes, where part of the catches of the species cannot be identified, this part shall be attributed in proportion of the catch composition for the identifiable part in the catches.
All catches of fishery products covered by this Annex shall be weighed in their entirety after transport upon arrival at the approved and registered weighing facility referred to in point 1.
By way of derogation to point 7, the sampling provisions laid down in Annex II(B)(i) and II(B)(iii) may apply to determine the catch composition after transport of fishery products landed unsorted and the weight of fishery products in standardised boxes and standardised containers.
In addition to the data required in Article 68(4) and (5) of Regulation (EC) No 1224/2009, and without prejudice to Article 68(6) of the same Regulation, the transport document shall include the following information:
the transport seal number(s), where available;
indication that fishery products are to be weighed after transport under Article 60(3)(c) of Regulation (EC) No 1224/2009;
the estimated date and time of arrival at the destination referred to in Article 68(4)(a) of Regulation (EC) No 1224/2009; and
the number of boxes or containers transported, per transport unit, broken down by species, presentation and relevant geographical area, where applicable.
Member States shall effectively monitor compliance with the conditions set out in this Annex at all stages of the weighing process and ensure that natural persons who commit and legal persons who are held liable for, infringements of these rules are subject to effective, proportionate, and dissuasive sanctions and other enforcement measures, in accordance with Title VIII of Regulation (EC) No 1224/2009.
The procedures referred to in Section B shall be conducted under at least one of the following conditions:
in the presence of officials;
in weighing facilities that are fully or partially publicly owned or operated and are subject to dedicated control, inspection and transparency mechanisms, in order to exclude any direct or indirect conflict of interest that may affect the impartial exercise of their tasks;
by independent third-party weighers complying with the minimum conditions laid down in Article 3(3) of Implementing Regulation (EU) 2024/1474, subject to dedicated control, inspection and transparency mechanisms;
subject to alternative control measures requested under point 18, based on risk management and ensuring compliance with Section B, such as the use of remote electronic monitoring system (REM) with closed-circuit television (CCTV) or equivalent technology. Those measures shall be submitted to the Commission in accordance with Article 10(2)(d) of this Regulation.
When REM systems with CCTVs are used, in accordance with point 11(d), the competent authorities of the Member State of weighing shall:
review their installation to ensure the effectiveness of such systems for the monitoring of weighing, sampling and catch registration activities;
have access to the recordings, upon request; and
review a minimum number of the CCTV recordings as part of the control and inspection measures referred to in Article 8.
Weighing facilities shall:
be registered and approved by competent authorities of the Member States of weighing; and
have the capacity to distinguish catches from each vessel, ensuring the clear identification of all fishery products prior to weighing.
Weighing facilities that, on the basis of risk management taking into account at least the risk factors listed in Article 8(3) of this Regulation, are identified as posing a risk of non-compliance with the rules laid down in this Annex shall be subject to a physical inspection by the competent authorities of the Member State concerned within 12 months of their approval, or, where the identification occurs at a later stage, within 12 months from the date of that identification. Such inspection shall at least include the verification of:
the number and models of weighing systems to be used at the weighing facility, and their location of installation;
the maximum daily weighing capacity in the case of conveyor belt and batch weighing systems;
drawings of the catch handling and production process of fishery products from arrival at the facility to final product storage, including locations of weighing systems, sampling and sorting areas, the storage area and REM systems with CCTVs, where relevant;
where continuous weighing systems are used, a copy of the technical wiring schematics and possible connections;
the point of contact for the operator or their representative during weighing operations; and
how access to weighing facility, weighing systems, weighing information, records, and, where relevant, REM systems with CCTVs will be ensured.
Authorised weighing operators shall notify the competent authority about any changes to the approved weighing systems and weighing facilities in advance of their use. The weighing systems and weighing facilities shall not be used without explicit authorisation by the competent authorities.
Unless a shorter period is set by the Member State, the approval issued by the competent authority shall be of the limited duration not exceeding five consecutive years.
The competent authority referred to in point 16 shall have the right to revoke the approval of the weighing facility if the above conditions are not met or if there is evidence of unsatisfactory weighing and catch registration activities.
Member States may request alternative conditions to those laid down in points 4, 6, 7, 8, 11, 13 and 14 of this Annex, provided that such alternative conditions:
concern special situations relating to:
catching vessels below 12 meters length overall;
small quantities landed, weighed or transported;
the findings of independent scientific studies or bodies that are recognised at Union, national or international level;
the inter-box weight of fishery products landed in standardised boxes;
the state of processing of fishery products;
fishery products not subject to quota or fisheries specific to Member States;
authorised weighing operators; or
the use of new technology; and
ensure the same or a higher level of accuracy in weighing and catch-registration results.