Operators of an installation shall identify, within the system boundaries of an installation, the production process of goods to which the same functional unit applies. The identification of the production process shall ensure that relevant inputs, outputs and emissions can be monitored in accordance with Annex II and that direct and indirect emissions, where relevant, can be attributed to goods to which a functional unit applies.
The quantities of goods produced in tonnes classified under the same CN code shall constitute the functional unit, except for the goods referred to in paragraphs 3, 4 and 5.
For electricity, the kWh shall constitute the functional unit.
For fertilisers, the following shall constitute the functional unit:
for CN codes 28080000, 2814, 3105, the kilograms of nitrogen contained in the goods produced under the respective CN codes;
for the CN codes of fertilisers other than the ones listed in point (a), the supplementary units as laid down in Regulation (EEC) No 2658/87 of the goods produced under the respective CN codes.
For CN codes 25231000, 25232100, 25232900, 25239000, the tonnes of clinker contained in the goods produced under the respective CN codes shall constitute the functional unit.
Where goods to which the same functional unit applies are produced using different production routes within an installation, a single production process shall be used encompassing all production routes.
Splitting an installation into different installations, with the result that production routes otherwise pertaining to a single production process are carried out in separate installations, shall only be allowed where the operators demonstrate valid commercial reasons for this split that are related to their economic activity. Commercial reasons shall be considered as valid where circumventing Regulation (EU) 2023/956 is not their main purpose or one of their main purposes.
Where goods to which different functional units apply are produced through the same processes, the operators may determine a single multifunctional production process. In that case, attribution rules in accordance with point A.2 of Annex III shall apply. In situations specified in point A.4 of that Annex, the determination of a single multifunctional production process shall be mandatory.
Where precursors relevant for complex goods are produced in the same installation as the complex goods, and where the respective precursors are not transferred out for sale or use in other production processes, the production of precursors and complex goods may be covered by a joint production process. In that case, monitoring and calculation of embedded emissions of the precursors and complex goods shall be carried out jointly.