Annex VI to Delegated Regulation (EU) 2023/2534 is amended as follows:
point 1 is amended as follows:
in the first subparagraph, the introductory wording is replaced by the following:
‘For electric household tumble dryers, the technical documentation referred to in Article 3(1), point (b)(i), shall include the following information:’;
point (g) is replaced by the following:
‘(g) the values for the technical parameters set out in Table 5 for the eco programme, which are considered as the declared values for the purpose of the verification procedure set out in Annex IX.’;
in Table 5, the header is replaced by the following:
‘Table 5
Declared technical parameters for electric household tumble dryers’;
in point 2, the first subparagraph is replaced by the following:
‘For gas-fired tumble dryers, the technical documentation referred to Article 3(1), point (b)(i), shall include the information listed in paragraph 1, points (a) to (f) of this Annex, and the information set out in Table 6 for the eco programme. The values in Table 6 are considered as the declared values for the purpose of the verification procedure in Annex IX.’.
Table 6 is amended as follows:
the header is replaced by the following:
‘Table 6
Declared technical parameters for gas-fired household tumble dryers’;
the fourth row on the gas consumption of the eco programme at partial load is replaced by the following:
‘Gas consumption of the eco programme at partial load (Egdry,½) | kWh/drying cycle | X,XX’
the tenth, eleventh and twelfth rows on the programme duration for the eco programme are replaced by the following:
‘Programme duration for the eco programme at full load (Tdry) | h:min | X:XX
Programme duration for the eco programme at partial load (Tdry½) | h:min | X:XX
Weighted programme duration for the eco programme (Tt) | h:min | X:XX’
point 3 is replaced by the following:
‘3. Where the information included in the technical documentation for a particular household tumble dryer has been obtained:
from a model that has the same technical characteristics relevant for the technical information to be provided but is produced by a different supplier;
by calculation on the basis of design or extrapolation from another model of the same or a different supplier,
the technical documentation shall include the details of the calculation, the assessment undertaken by suppliers to verify the accuracy of the calculation and, where appropriate, the declaration of identity between the models of different suppliers.’.