Art. 19a Regulation (EU) 2025/202

Remedial measures for cod in the Kattegat in 2026

In forcesince 1 Jan 2026cited 1×
1.

Union fishing vessels fishing in the Kattegat with bottom trawls and seines [Gear codes: OTB, OTT, OT, TBN, TBS, TB, TX, PTB, SDN, SSC, SX.] with minimum mesh size of 70 mm shall use one of the following selective gears:

(a)

sorting grid with maximum 35 mm bar spacing, with an unblocked fish outlet;

(b)

sorting grid with maximum 50 mm bar spacing separating flatfish and roundfish, with an unblocked fish outlet for roundfish;

(c)

seltra panel with 300 mm square mesh size; or

(d)

highly selective gear, the technical attributes of which shall result, according to a scientific study assessed by the STECF, for fishing vessels exclusively carrying on board such a gear, in a proportion of cod catches of less than 1,5 % of total catches.

2.

Union fishing vessels participating in a project run by a Member State and having functioning equipment for fully documented fisheries may use a gear that complies with the requirements set in Part B of Annex V, to Regulation (EU) 2019/1241, except for the gears that comply with the alternative requirement set in the second sentence of the footnotes in point 1.1 of that Part. By 31 March, the Member State concerned shall communicate a list of such vessels to the Commission.

3.

This Article does not apply to fishing operations conducted for the exclusive purpose of scientific investigations, provided that those investigations are carried out in compliance with Article 25 of Regulation (EU) 2019/1241.