ANNEX V, Regulation (EU) 2025/111

In forcesince 23 Jan 2025

Annex Vb (Part-ML) to Regulation (EU) No 1321/2014 is amended as follows:

(1)

in point ML.1, point (a) is replaced by the following:

‘(a) In accordance with Article 3(2), this Annex (Part-ML) applies to the following other than complex motor-powered aircraft not listed in the air operator certificate of an air carrier licensed in accordance with Regulation (EC) No 1008/2008:

(1)

aeroplanes of 2730 kg maximum take-off mass (MTOM) or less;

(2)

helicopters of 1200 kg MTOM or less, certified for a maximum of up to four occupants;

(3)

other ELA2 aircraft;

(4)

non-conventional aircraft with a MTOM of:

(i)

1200 kg or less if they can maintain zero horizontal speed in flight; or

(ii)

2730 kg or less for other than those in point (i).’;

(2)

point (d) of point ML.A.302 is amended as follows:

(i)

point (2)(f) is replaced by the following:

‘(f) in the case of aeroplanes, as applicable to the aircraft power plant:

(i)

operational tests for power and revolutions per minute (rpm), magnetos, fuel and oil pressure, engine temperatures;

(ii)

for engines equipped with automated engine control, the published run-up procedure;

(iii)

for dry-sump engines, engines with turbochargers and liquid-cooled engines, an operational test for signs of disturbed fluid circulation;

(iv)

in respect of a power plant other than piston engine, the maintenance tasks as defined in the ICA issued by the DAH of the aeroplane;’;

(ii)

the last paragraph is replaced by the following:

‘As long as this Annex does not specify an MIP for aircraft other than aeroplanes, sailplanes and balloons, their AMP shall be based on the ICA issued by the DAH, as referred to in point (c)(2)(b).’;

(3)

in Appendix III, the following points (ca) and (cb) are inserted:

‘(ca) the performance of maintenance on the power plant that would require disassembly of engine(s), main batteries or fuel cell(s), other than removing them from the aircraft and reinstalling them back (including removal/installation of engine bearings);

(cb)

the performance of maintenance on high-pressure reservoirs and components belonging to high-pressure lines/systems related to the power plant;’