Obligations regarding LDAR surveys should reflect good practices. LDAR surveys should be primarily aimed at finding and eliminating as quickly as possible leaks by repair or replacement of the leaking component, rather than quantifying them, and those areas with a higher risk of leaks should be checked more frequently. The determination of the frequency of LDAR surveys and the decision to repair or replace a component should be guided not only by the need to repair or replace components from which methane is escaping above the methane emission threshold but also by operational considerations, taking into account risks to safety. Thus, where a higher risk to safety or higher risk of methane emissions is identified, the competent authorities should be allowed to recommend more frequent LDAR surveys for the relevant components or the replacement of components with technology that is less prone to leaks. All leaks, irrespective of their size, should be surveyed and checked, as small leaks can develop into larger ones. Leak repairs should be followed by confirmation that they have been effective. In order to allow for new or more advanced components or technologies for the detection of methane emissions to be used, the size of methane loss at or above which repair is required should be specified, while leaving to the operators the choice of detection device. Where appropriate, it should be possible to use detection technologies, such as continuous monitoring, as part of LDAR surveys as long as they fulfil the requirements for advanced detection technologies of this Regulation. Best performing operators producing or processing oil or natural gas should be able to apply different LDAR survey frequencies, subject to the fulfilment of the conditions in this Regulation and the approval of the competent authorities.
Recital 35, Regulation (EU) 2024/1787
In forcesince 13 Jun 2024