Art. 4 Regulation (EU) 2023/1640

Yield methods

In forcesince 5 Jun 2023
1.

Where a yield method is used, economic operators may use one of the two methods described below in order to obtain a yield factor to be applied to the common process of the fuel production:

(a)

Yield Method A. The yields of the various products shall be first observed and recorded when the processing units operate with only pure fossil feedstock or, for specific applications (e.g. limited concentrations) on pilot scale units representative of the commercial scale ones. Then, a share of biomass feedstocks shall be added to the input stream and the incremental effect on the yields shall be observed and recorded. The bio-content shall be then attributed to each product in proportion to the increase in its production. Each yield factor shall only be valid for the reference inputs and process conditions, for which the yield factor had been established. Economic operators may define different yield factors to refer to different processes and operating conditions. Member States, in accordance with the rules stipulated in this Regulation, may define the yield factors that economic operators have to use on their territory. If different yield factors are used, a radiocarbon 14C test shall be carried out each time a new yield factor is used and the correlation between reference inputs and process conditions shall be checked and, if needed, updated.

(b)

Yield Method B. This method shall establish a relationship between the bio-input and the bio-output of a co-processing unit. The conversion factor shall be determined by running several batches of feedstock at known co-processing conditions, including a full characterization of inputs and outputs of the system. After having determined this yield factor correlation, it can be applied to the biogenic feedstock of the same type and quality that is used in the same co-processing unit working at the same operating conditions.

2.

Economic operators may only use yield methods as a main method if the system is kept under reference operating conditions defined by them, including for feedstock quality. If economic operators use a yield method, they shall use the radiocarbon 14C testing as a control method to verify its yield factor at least whenever they change the reference operating conditions and in accordance with article 6.

3.

The economic operator shall demonstrate the continuous operation of the plant at known co-processing conditions by running each specific bio-input through 14C testing, used to calculate its specific conversion factor.