Where the technical specifications set out in Part 2 of Annexes II to XIII and in Annex XIV, Part 2, Sections D and E with regard to the respective requirements listed in Annex II to Regulation (EU) 2019/2144 are met, the type-approval authority shall grant an EU type-approval and issue a type-approval certificate number in accordance with the method set out in Annex IV of Commission Implementing Regulation (EU) 2020/683.
The EU type-approval certificate, referred to in Article 28(1) of Regulation (EU) 2018/858, shall be drawn up in accordance with:
Part 3 of Annex II for the item referred to in point (a) of Article 5(1);
Part 3 of Annex III for the item referred to in point (b) of Article 5(1);
Annex IV, Part 3, Section A for the item referred to in point (c) of Article 5(1);
Part 3 of Annex V for the item referred to in point (d) of Article 5(1);
Part 3 of Annex VI for the item referred to in point (e) of Article 5(1);
Part 3 of Annex VII for the item referred to in point (f) of Article 5(1);
Annex VIII, Part 3, Section A for the item referred to in point (g) of Article 5(1);
Part 3 of Annex IX for the item referred to in point (h) of Article 5(1);
Part 3 of Annex X for the item referred to in point (i) of Article 5(1);
Part 3 of Annex XI for the item referred to in point (j) of Article 5(1);
Annex XIII, Part 3, Section A for the item referred to in point (k) of Article 5(1); and
Annex XIV, Part 3, Section A for the item referred to in point (l) of Article 5(1).
In accordance with the second subparagraph of Article 6(5) of Regulation (EU) 2018/858, an EU type-approval may be granted for vehicles exceeding the maximum authorised dimensions set out in point 1.1 of Sections C, D and E of Part 2 of Annex XIII to this Regulation, in which case the remark ‘maximum authorised dimensions derogation’ shall be included in point 52 of the type-approval certificate and the certificate of conformity.
An EU type-approval may be granted for vehicles intended for the transport of indivisible loads, the dimensions of which exceed the maximum authorised dimensions set out in point 1.1 of Sections C, D and E of Part 2 of Annex XIII to this Regulation, in which case the type-approval certificate and the certificate of conformity shall clearly indicate that the vehicle is intended for the transport of indivisible loads only.