The technical documentation referred to in point 1(d) of Article 3 shall include the following elements:
a general description of the model allowing it to be unequivocally and easily identified;
references to the harmonised standards applied or other measurement standards used;
specific precautions to be taken when the model is assembled, installed, maintained or tested;
the values for the technical parameters set out in Table 4; these values are considered as the declared values for the purpose of the verification procedure in Annex IX;
the details and the results of calculations performed in accordance with Annex IV;
testing conditions if not described sufficiently in point (b);
equivalent models, if any, including model identifiers.
These elements shall also constitute the mandatory specific parts of the technical documentation that the supplier shall enter into the database, pursuant to point 5 of Article 12 of Regulation (EU) 2017/1369.
PARAMETER | DECLARED VALUE | UNIT
Rated capacity in place settings | X | —
Eco programme energy consumption (EPEC) rounded to three decimal places | X,XXX | kWh/cycle
Standard programme energy consumption (SPEC) rounded to three decimal places | X,XXX | kWh/cycle
Energy Efficiency Index (EEI) | X,X | —
Eco programme water consumption (EPWC) rounded to one decimal place | X,X | l/cycle
Cleaning performance index (IC) | X,XXX | —
Drying performance index (ID) | X,XXX | —
Duration of the eco programme (Tt) rounded to the nearest minute | X:XX | h:min
Power consumption in off-mode (Po) rounded to two decimal places (if applicable) | X,XX | W
Power consumption in standby mode (Psm) rounded to two decimal places (if applicable) | X,XX | W
Does standby mode include the display of information? | Yes/No | —
Power consumption in standby mode (Psm) in condition of networked standby (if applicable), rounded to two decimal places | X,XX | W
Power consumption in delay start (Pds) (if applicable) rounded to two decimal places | X,XX | W
Airborne acoustical noise emissions | X | dB(A) re 1 pW
Where the information included in the technical documentation for a particular household dishwasher model has been obtained by any of the following methods, or both:
from a model that has the same technical characteristics relevant for the technical information to be provided but is produced by a different supplier;
by calculation on the basis of design or extrapolation from another model of the same or a different supplier,
the technical documentation shall include the details of such calculation, the assessment undertaken by suppliers to verify the accuracy of the calculation and, where appropriate, the declaration of identity between the models of different suppliers.