3 ANNEX III FORMAT FOR THE QUALITY CHECK REPORT ACCOMPANYING THE DATA REFERRED TO IN ANNEX II, Decision_act (EU) 2019/2193

In forcesince 20 Dec 2019

...

Quality check report for the data submitted for the purposes of Directive 2012/19/EU of the European Parliament and of the Council of 4 July 2012 on waste electrical and electronic equipment (OJ L 197, 24.7.2012, p. 38).

...

...

...

...

This quality check report shall be available

to the public (on the Commission’s webpage):

□Yes/□ Yes, with the exception of section(s): ....

□No

If no, please provide explicit information on which sections should be confidential and the reasons for confidentiality: ...

to the members of the Technical Adaptation Committee (TAC) and the Expert Group on waste electrical and electronic equipment (WEEE):

□Yes/□ Yes, with the exception of section(s): ...

□No,

If no, please provide explicit information on which sections should be confidential and the reasons for confidentiality: ...

Please indicate the methodology used for the calculation of the quantity of EEE placed on the market in accordance with Commission Implementing Regulation (EU) 2017/699 of 18 April 2017 establishing a common methodology for the calculation of the weight of electrical and electronic equipment (EEE) placed on the market of each Member State and a common methodology for the calculation of the quantity of waste electrical and electronic equipment (WEEE) generated by weight in each Member State (OJ L 103, 19.4.2017, p. 17).

...

Please indicate the methodology applied for the calculation of the WEEE collection rate.

If the methodology applied is based on the average weight of EEE placed on the market in the three preceding years, please provide data on the quantity of EEE placed on the market in the three years preceding the reference year:

Total weight (tonnes) of EEE placed on the market (POM) of a Member State

Year (one year before the reference year) |

Year (two years before the reference year) |

Year (three years before the reference year) |

Average weight of the three years=

(sum of lines 1 + 2+3, divided by 3)

Please describe the source of data for the different items listed below (e.g. census/national statistics/reporting obligations for business or certified business units/agencies/associations/surveys of waste composition/specific impact assessments that national law may have, and relevant regulations).

Please specify the sources used for the collection of data on EEE placed on the market.

...

Please report the data on the weight of WEEE generated as calculated using the WEEE calculation tool and specify data updates of the WEEE calculation tool, if any.

For Member States reporting the WEEE collection rate calculated on the basis of WEEE generated this data is obligatory. Member States reporting the WEEE collection rate calculated on the basis of the average weight of EEE placed on the market in the three preceding years may provide this data on a voluntary basis.

...

Please specify the sources used for the collection of data on WEEE collected through all routes. Please take into consideration that, pursuant to Article 7(2) of Directive 2012/19/EU, the quantity of WEEE collected shall be the amount of WEEE that has been:

(a)

received by collection and treatment facilities;

(b)

received by distributors;

(c)

separately collected by producers or third parties acting on their behalf.

Please specifically state if systems have been set up to allow holders and distributors to return WEEE at least free of charge in accordance with Article 5 of Directive 2012/19/EU and provide information about the data that you may receive from these systems.

...

Please take into consideration that, pursuant to Article 11(2) of Directive 2012/19/EU, you shall use data on the weight of WEEE, its components and materials or substances entering (input) a preparing for re-use or recycling or recovery facility, after proper treatment in accordance with Article 8(2) of Directive 2012/19/EU.

Please specify the sources used for data on preparing for re-use, recycling and recovery of WEEE pursuant to Article 11(4) of Directive 2012/19/EU.

Please indicate the distinction between the input to a preparing for re-use facility, to a recycling facility, to an incineration (or smelting process) or to the (energy) recovery facility.

...

Please specify the sources used for the collection of data on WEEE treated in the Member State and on WEEE treated in another Member State or outside the Union.

Please also give a general description of treatment systems available in the Member State and specify if treatment requirements or minimum quality standards for the treatment of collected WEEE in the Member State are different from or go beyond Annex VII of Directive 2012/19/EU. In such a case, please provide a description of these requirements or standards.

...

Please describe the quality of the diverse sources used (including challenges with regard to the quality of the data and how you intend to improve the quality in the future).

...

In case, prior to being collected by the Member States, data is collected by operators under EEE categories other than those specified in Directive 2012/19/EU, or under sub categories, please explain which EEE categories or sub-categories are applied and how data under these categories are transformed into data under the EEE categories of Directive 2012/19/EU

Please provide a description of the national measures aimed at promoting the achievement of the collection, preparing for re-use and recycling, and recovery targets.

Please also provide information about measures taken to inform users of EEE and encourage their participation in WEEE management in accordance with Article 14 of Directive 2012/19/EU.

If quantities of WEEE ‘Treated in other Member States’ or ‘Treated outside of the EU’ are reported, please specify:

if these exports are considered for the calculation of the recovery rates and the preparing for re-use and recycling rates;

how the recovery rates and the preparing for re-use and recycling rates for these exported amounts have been derived.

In case there is a requirement for documentary evidence additional to the proof required under Article 10(2) of Directive 2012/19/EU to be submitted for the approval of the export by the competent authorities, please describe the documentary evidence required.

...

Please describe actions undertaken to avoid double counting of imported WEEE, which shall not count towards the achievement of the targets and not be reported under treatment, preparing for re-use, recycling and recovery in the importing Member State.

Please describe any corrections to account for imports and exports for instance to consider private imports and exports or misleading declarations (used EEE instead of WEEE) or others.

...

Please describe the process used to establish the validity of the data.

Please also provide details on the inspection and monitoring systems applied in the Member State to verify the implementation of Directive 2012/19/EU.

...

C.1: Do the data sources addressed before cover the entire sector?

□Yes/□ No

C.2: Are any substantiated estimates used regarding EEE placed on the market pursuant to Implementing Regulation (EU) 2017/699?

□Yes/□ No

C.3: Are any substantiated estimates used regarding WEEE collected and treated which are taken into consideration for the reporting relating to the achievement of the relevant targets?

□Yes/□ No

If yes, please describe the methodology for obtaining such estimates and provide relevant supporting documents for such estimates.

...

C.4: Are any substantiated estimates used regarding the average percentage of recycled and recovered materials originating from WEEE and of components of WEEE which are taken into consideration for the reporting relating to the achievement of the relevant targets?

□Yes/□ No

If yes, please describe the methodology for obtaining such estimates and provide relevant supporting documents for such estimates.

...

C.5: What portion (%) of WEEE collected and treated is covered, or estimated to be covered, by the reporting scheme?

...

If mandatory data is missing, please describe the reasons for these gaps and provide information about the measures taken to overcome this situation.

...

Please indicate whether any of the following situations has occurred:

1.

The quantity of EEE placed on the market is less than 10 kg per inhabitant per year.

□Yes/□ No

2.

The quantity of WEEE collected is more than the quantity of EEE placed on the market.

□Yes/□ No

3.

WEEE collection rate is higher than 75 % of EEE placed on the market or higher than 100 % of WEEE generated?

□Yes/□ No

4.

The quantity of WEEE treated is more than the quantity of WEEE collected.

□Yes/□ No

5.

The quantity of WEEE recycled (including preparing for re-use) is more than the quantity of WEEE recovery (incl. preparing for re-use).

□Yes/□ No

6.

The Recycling rate (including preparing for re-use) exceeds 95 %.

□Yes/□ No

7.

The Recovery rate (including preparing for re-use) exceeds 99 %.

□Yes/□ No

8.

Break in time series (significant changes of the amounts reported over time)

□Yes/□ No

If the response for one or more of the questions is yes, please provide additional information on the occurrence and related reasons.

...

Please describe and provide explanations for any significant methodological changes in the data collection or data validation approach or in the methodologies applied for the calculation of the WEEE collection and recovery rates for the current reference year in relation to the approaches and methodologies applied for previous reference years.

...

Please provide any other relevant information source, including reports addressing aspects of the data quality, coverage or other aspects of enforcement such as reports from producer responsibility organisations on the achievements as regards WEEE collection, treatment and recycling, reports on best practice on WEEE collection and treatment, reports on imports and exports of WEEE and any other source of data and information related to WEEE.

...