Where the released fuel amounts of a fuel stream are used only for combustion in sectors covered by Annex III to Directive 2003/87/EC, the scope factor shall be set at 1.
Where the released fuel amounts of a fuel stream are used only for combustion in sectors covered by Chapters II and III of Directive 2003/87/EC, with the exception of installations excluded under Article 27a of that Directive, the scope factor shall be set at zero, provided that the regulated entity demonstrates that double counting referred to in Article 30f(5) of Directive 2003/87/EC was avoided.
The regulated entity shall determine a scope factor for each fuel stream either by applying the methods referred to in paragraph 2, or a default value in accordance with paragraph 3, depending on the applicable tier.
The regulated entity shall determine the scope factor on the basis of one or more of the following methods, in accordance with the requirements of the applicable tier as set out in Annex IIa to this Regulation:
methods based on the physical distinction of fuel flows, including methods based on the distinction of geographical region or based on the use of separate measuring instruments;
methods based on the chemical properties of fuels, which allow regulated entities to demonstrate that the relevant fuel can only be used for combustion in specific sectors, due to legal, technical or economic reasons;
use of fiscal marker in accordance with Council Directive 95/60/EC [Council Directive 95/60/EC of 27 November 1995 on fiscal marking of gas oils and kerosene (OJ L 291, 6.12.1995, p. 46).];
use of the verified annual emissions report referred to in Article 68(1);
chain of traceable contractual arrangements and invoices (‘chain of custody’), representing the whole supply chain from the regulated entity to the consumers, including final consumers;
use of national markers or colours (dyes) for fuels, based on national legislation;
indirect methods allowing an accurate differentiation of the end uses of the fuels at the time when they are released for consumption, such as sector-specific consumption profiles, typical ranges of capacity of consumers’ fuel consumption levels, and pressure levels such as those of gaseous fuels, provided that the use of that method is approved by the competent authority. The Commission may provide guidelines on applicable indirect methods.
Where subject to the required tiers, applying the methods listed in paragraph 2 is technically not feasible or would incur unreasonable costs, the regulated entity may use a default value of 1.
By way of derogation from paragraph 3, the regulated entity may apply a default value lower than 1, provided that:
for the purposes of reporting emissions in the reporting years 2024 to 2026 the regulated entity demonstrates to the satisfaction of the competent authority that using default values lower than 1 leads to a more accurate determination of emissions, or
for the purposes of reporting emissions in the reporting years as from 1 January 2027 the regulated entity demonstrates to the satisfaction of the competent authority that using default values lower than 1 leads to a more accurate determination of emissions and that at least one of the following conditions is met:
the fuel stream is a de-minimis fuel stream;
the default value for the fuel stream is not lower than 0,95 for fuel uses in sectors covered by Annex III to Directive 2003/87/EC or not higher than 0,05 for fuel uses in sectors not covered by that Annex.
Where, for a fuel stream, the regulated entity uses more than one method listed in paragraphs 2, 3 and 4, it shall determine the scope factor as the weighted average of the different scope factors resulting from the use of each method. For each method used, the regulated entity shall submit information on the type of method, the associated scope factor, released fuel amount and the code from the common reporting format for national greenhouse gas inventory systems, as approved by the respective bodies of the United Nations Framework Convention on Climate Change (Common Reporting Format (CRF) code), at the level of detail available.
By way of derogation from paragraph 1 of this Article and Article 75i, a Member State may require regulated entities to use a specific method referred to in paragraph 2 of this Article or a default value for a certain fuel type or in a certain region within their territory. The use of default values on national level shall be subject to the approval of the Commission.
When approving the default value in accordance with the first subparagraph, the Commission shall consider the appropriate level of harmonisation of methodologies between Member States, the balance between accuracy, administrative efficiency and cost pass-on implications for consumers, as well as possible risk of evasion of obligations under Chapter IVa of Directive 2003/87/EC.
Any default value for the national fuel stream used under this paragraph shall not be lower than 0,95 for fuel uses in sectors covered by Annex III to Directive 2003/87/EC or not higher than 0,05 for fuel uses in sectors not covered by that Annex.
The regulated entity shall specify the applied methods or default values in the monitoring plan.