Art. 43 Regulation (EU) 2018/2066

Determination of emissions

In forcesince 1 Jul 2024cited 6×
1.

The operator shall determine the annual emissions from an emission source over the reporting period by summing up over the reporting period all hourly values of the measured greenhouse gas concentration multiplied by the hourly values of the flue gas flow, where the hourly values shall be averages over all individual measurement results of the respective operating hour.

In the case of CO2 emissions, the operator shall determine annual emissions on the basis of equation 1 in Annex VIII. CO emitted to the atmosphere shall be treated as the molar equivalent amount of CO2.

In the case of nitrous oxide (N2O), the operator shall determine annual emissions on the basis of the equation in subsection B.1 of section 16 of Annex IV.

2.

Where several emission sources exist in one installation and cannot be measured as one emission source, the operator shall measure emissions from those sources separately and add the results to obtain the total emissions of the gas in question over the reporting period.

3.

The operator shall determine the greenhouse gas concentration in the flue gas by continuous measurement at a representative point through one of the following:

(a)

direct measurement;

(b)

in the case of high concentration in the flue gas, calculation of the concentration using an indirect concentration measurement applying equation 3 in Annex VIII and taking into account the measured concentration values of all other components of the gas stream as laid down in the operator's monitoring plan.

4.

Where relevant, the operator shall determine separately any CO2 amount stemming from biomass. For this purpose, the operator may use:

(a)

a calculation based approach, including approaches using analyses and sampling based on EN ISO 13833 (Stationary source emissions — Determination of the ratio of biomass (biogenic) and fossil-derived carbon dioxide — Radiocarbon sampling and determination);

(b)

another method based on a relevant standard, including ISO 18466 (Stationary source emissions — Determination of the biogenic fraction in CO2 in stack gas using the balance method);

(c)

an estimation method published by the Commission.

Where the method proposed by the operator involves continuous sampling from the flue gas stream, EN 15259 (Air quality — Measurement of stationary source emissions — Requirements for measurement sections and sites and for the measurement objective, plan and report) shall be applied. The sampling plan pursuant to Article 33 shall be commensurate with the frequency of analysis in accordance with Annex VII to this Regulation and ensure representativeness to cover the whole reporting year.

For the purpose of this paragraph, Article 38(5) shall apply.

Where the method proposed by the operator involves continuous sampling from the flue gas stream and the installation consumes natural gas from the grid, the operator shall subtract the CO2 stemming from any biogas contained in the natural gas from the total measured CO2 emissions. The biomass fraction of the natural gas shall be determined in accordance with Articles 32 to 35.

4a.

The operator shall use the biomass fraction determined in accordance with paragraph 4 as the zero-rated biomass fraction, if the following conditions are fulfilled for all fuels or materials leading to emissions to which the measurement-based methodology is applied:

(i)

according to the first to sixth subparagraphs of Article 38(5) of this Regulation, the criteria laid down in paragraphs 2 to 7 and 10 of Article 29 of Directive (EU) 2018/2001 do not apply; or

(ii)

100% of the biomass fraction of the used fuel or material are covered by the evidence relevant according to Article 38(5) of this Regulation.

The condition (ii) shall be deemed fulfilled for biogas monitored in accordance with Article 39(4) of this Regulation.

Where conditions (i) and (ii) are not fulfilled for fuels or materials leading to emissions to which the measurement-based methodology is applied, the operator shall determine the zero-rated biomass fraction for these fuels or materials using a calculation-based approach in accordance with Articles 24 to 39a of this Regulation.

4b.

The operator may deduct from the total emissions of the emission source the emissions from zero-rated biomass determined in accordance with paragraph 4a of this Article.

Where the method proposed by the operator for the determination of the zero-rated biomass fraction involves continuous sampling from the flue gas stream and the installation consumes natural gas from the grid, the operator shall determine the physical CO2 amount of the biogas used in accordance with Articles 32 to 35 of this Regulation and deduct the respective CO2 amount from the zero-rated CO2 determined in accordance with paragraph 4a of this Article.

4c.

Where the operator uses zero-rated RFNBOs, RCFs or synthetic low-carbon fuels in a process for which the measurement-based methodology is applied, the operator may deduct from the total emissions the emissions from zero-rated RFNBOs, RCFs or synthetic low-carbon fuels.

The emissions from zero-rated RFNBOs, RCFs or synthetic low-carbon fuels shall be determined using a calculation-based approach in accordance with Articles 24 to 39a of this Regulation. They shall equal the activity data of the relevant fuel multiplied by the preliminary emission factor and the zero-rated RFNBO or RCF fraction or the zero-rated synthetic low-carbon fraction.

5.

The operator shall determine the flue gas flow for the calculation in accordance with paragraph 1 by one of the following methods:

(a)

calculation by means of a suitable material balance, taking into account all significant parameters on the input side, including for CO2 emissions at least input material loads, input airflow and process efficiency, and on the output side, including at least the product output and the concentration of oxygen (O2), sulphur dioxide (SO2) and nitrogen oxides (NOx);

(b)

determination by continuous flow measurement at a representative point.

  • Regulation (EU) 2023/2122Lawamends

  • Regulation (EU) 2024/2493Lawamends

  • Regulation (EU) 2020/2085Lawamends

  • EBeV 203012Law

    … Analysen und Probenahmen gemäß Artikel 43 Absatz 4 Buchstabe a der Durchführungsverordnung (EU) 2018/2066, 2. eine Methode gemäß Artikel 43 Absatz 4 Buchstabe b der Durchführungsverordnung (EU) 2018/2066 oder 3. eine gemäß § 9 …

  • Opinion of Advocate General Martín y Pérez de Nanclares delivered on 9 September 2026.Decision

    … 3 Nrn. 21, 21a, 23c und 23d sowie aus den Art. 24, 30, 38 und 43 der Durchführungsverordnung 2018/2066 ergibt sich, dass der Anlagenbetreiber die Emissionen aus Biomasse mit Emissionsfaktor null von den Gesamtemissionen der Quelle …

    9 Sep 2026 · 62025TC0702

  • EBeV 203012Law