This Appendix describes the verification of trip conditions and the calculation of the final RDE emissions result for OVC-HEVs. The method proposed in the Appendix will undergo review in order to find a more complete one.
Mtis the weighted distance specific mass of gaseous pollutants [mg/km] or particle number [#/km], respectively emitted over the complete trip
mtis the mass of gaseous pollutant [g] or particle number [#] emissions, respectively emitted over the complete trip
mt,CO2is the mass of CO2 [g] emitted over the complete trip
Muis the weighted distance-specific mass of gaseous pollutants [mg/km] or particle number [#/km], respectively emitted over the urban part of the trip
muis the mass of gaseous pollutant or the particle number emissions, respectively emitted over the urban part of the trip [mg]
mu,CO2is the mass of CO2 [g] emitted over the urban part of the trip
MWLTC,CO2is the distance specific mass of CO2 [g/km] for a test in charge sustaining mode over the WLTC
The gaseous and particle pollutant emissions of OVC-HEVs shall be evaluated in two steps. First, the trip conditions shall be evaluated in accordance with point 4. Second, the final RDE emissions result is calculated in accordance with point 5. It is recommended to start the trip in charge-sustaining battery status to ensure that the third requirement of point 4 is fulfilled. The battery shall not be charged externally during the trip.
It shall be verified in a simple three-step procedure that:
the trip complies with the general requirements, boundary conditions, trip and operational requirements, and the specifications for lubricating oil, fuel and reagents defined in points 4 to 8 of this Annex IIIa;
the trip complies with the trip conditions defined in Appendices 7a and 7b of this Annex IIIa.
the combustion engine has been working for a minimum cumulative distance of 12 km under urban conditions.
If the at least one of the requirements is not fulfilled, the trip shall be declared invalid and repeated until the trip conditions are valid.
For valid trips, the final RDE result is calculated based on a simple evaluation of the ratios between the cumulative gaseous and particle pollutant emissions and the cumulative CO2 emissions in three steps:
Determine the total gaseous pollutant and particle number emissions [mg;#] for the complete trip as mt and over the urban part of the trip as mu.
Determine the total mass of CO2 [g] emitted over the complete RDE trip as mt,CO2 and over the urban part of the trip as mu,CO2.
Determine the distance-specific mass of CO2 MWLTC,CO2 [g/km] in charge-sustaining mode for the individual vehicles (declared value for the individual vehicle) as described in the Regulation (EU) 2017/1151; Type I test, including cold start.
Calculate the final RDE emissions result as:
Mt mtmt,CO2 MWLTC,CO2for the complete trip;
Mu mumu,CO2 MWLTC,CO2for the urban part of the trip.’.