The purpose of physical protection of nuclear materials is to prevent unauthorized use and handling of these materials. Paragraph 3(a) of the Guidelines document calls for effective physical protection levels consistent with the relevant IAEA recommendations, in particular those set out in INFCIRC/225.
Paragraph 3(b) of the Guidelines document states that implementation of measures of physical protection in the recipient country is the responsibility of the Government of that country. However, the levels of physical protection on which these measures have to be based should be the subject of an agreement between supplier and recipient. In this context these requirements should apply to all States.
The document INFCIRC/225 of the International Atomic Energy Agency entitled “The Physical Protection of Nuclear Material” and similar documents which from time to time are prepared by international groups of experts and updated as appropriate to account for changes in the state of the art and state of knowledge with regard to physical protection of nuclear material are a useful basis for guiding recipient States in designing a system of physical protection measures and procedures.
The categorization of nuclear material presented in the attached table or as it may be updated from time to time by mutual agreement of suppliers shall serve as the agreed basis for designating specific levels of physical protection in relation to the type of materials, and equipment and facilities containing these materials, pursuant to paragraph 3(a) and 3(b) of the Guidelines document.
The agreed levels of physical protection to be ensured by the competent national authorities in the use, storage and transportation of the materials listed in the attached table shall as a minimum include protection characteristics as follows:
Use and Storage within an area to which access in controlled.
Transportation under special precautions including prior arrangements among sender, recipient and carrier, and prior agreement between entities subject to the jurisdiction and regulation of supplier and recipient States, respectively, in case of international transport, specifying time, place and procedures for transferring transport responsibility.
Use and Storage within a protected area to which access is controlled, i.e., an area under constant surveillance by guards or electronic devices, surrounded by a physical barrier with a limited number of points of entry under appropriate control, or any area with an equivalent level of physical protection.
Transportation under special precautions including prior arrangements among sender, recipient, and carrier, and prior agreement between entities subject to the jurisdiction and regulation of supplier and recipient States, respectively, in case of international transport, specifying time, place and procedures for transferring transport responsibility.
Materials in this category shall be protected with highly reliable systems against unauthorized use as follows:
Use and storage within a highly protected area, i.e., a protected area as defined for Category II above, to which, in addition, access is restricted to person whose trustworthiness has been determined, and which is under surveillance by guards who are in close communication with appropriate response forces. Specific measures taken in this context should have as their objective the detection and prevention of any assault, unauthorized access or unauthorized removal of material.
Transportation under special precautions as identified above for transportation of Category II and III materials and, in addition, under constant surveillance by escorts and under conditions which assure close communication with appropriate response forces.
Suppliers should request identification by recipients of those agencies or authorities having responsibility for ensuring that levels of protection are adequately met and having responsibility for internally co-ordinating response/recovery operations in the event of unauthorized use or handling of protected materials. Suppliers and recipients should also designate points of contact within their national authorities to co-operate on matters of out-of-country transportation and other matters of mutual concern.
[a] As identified in the Trigger List.
[b] Material not irradiated in a reactor or material irradiated in a reactor but with a radiation level equal to or less than 100 rads/hour at one metre unshielded.
[c] Less than a radiologically significant quantity should be exempted.
[d] Natural uranium, depleted uranium, and thorium and quantities of uranium enriched to less than 10 % not falling in Category III should be protected in accordance with prudent management practice.
[e] Although this level of protection is recommended, it would be open to States, upon evaluation of the specific circumstances, to assign a different category of physical protection.
[f] Other fuel which by virtue of its original fissile material content is classified as Category I or II before irradiation may be reduced one category levels while the radiation level from the fuel exceed 100 rads/hour at tone metre unshielded.
Material | Form | Category
I | II | III
Plutonium*[a]
Unirradiated*[b] | 2 kg or more | Less than 2 kg but more than 500 g | 500 g or less*[c]
Uranium-235
Unirradiated*[b] | | |
uranium enriched to 20 % 235U or more
5 kg or more | Less than 5 kg but more than 1 kg | 1 kg or less*[c]
uranium enriched to 10 % 235U but less than 20 %
| 10 kg or more | Less than 10 kg*[c]
uranium enriched above natural, but less than 10 % 235U*[d]
| — | 10 kg or more
Uranium-233
Unirradiated*[b] | 2 kg or more | Less than 2 kg but more than 500 g | 500 g or less*[c]
Irradiated fuel
Depleted or natural uranium, thorium or low-enriched fuel (less than 10 % fissile content)*[e][f] |