ANNEX I, Commission Regulation (EU) No 66/2014 of 14 January 2014 implementing Directive 2009/125…

In forcesince 14 Jan 2014

Cavities of domestic ovens (including when incorporated in cookers) shall comply with maximum Energy Efficiency Index limits as indicated in Table 1.

Domestic electric & gas oven

From 1 year after the entry into force | EEIcavity < 146

From 2 years after the entry into force | EEIcavity < 121

From 5 years after the entry into force | EEIcavity < 96

From 5 years after entry into force, for multi-cavity ovens (including when incorporated in cookers), at least one cavity shall comply with the maximum Energy Efficiency Index as indicated in Table 1 as applicable from 5 years after entry into force whereas the other cavities shall comply with the maximum Energy Efficiency Index as indicated in Table 1 as applicable from 2 years after entry into force.

The domestic hobs shall have the maximum energy consumption limits for electric hobs (ECelectric hob) and the minimum energy efficiency limits for gas-fired hobs (EEgas hob) as indicated in Table 2.

Electric hob

(ECelectric hob in Wh/kg)

Gas-fired hob

(EEgas hob in %)

From 1 year after the entry into force | ECelectric hob < 210 | EEgas hob > 53

From 3 years after the entry into force | ECelectric hob < 200 | EEgas hob > 54

From 5 years after the entry into force | ECelectric hob < 195 | EEgas hob > 55

The domestic range hoods shall have the maximum EEIhood and the minimum FDEhood limits as indicated in Table 3.

EEIhood | FDEhood

From 1 year after the entry into force | EEIhood < 120 | FDEhood > 3

From 3 years after the entry into force | EEIhood < 110 | FDEhood > 5

From 5 years after the entry into force | EEIhood < 100 | FDEhood > 8

From 1 year after the entry into force, the domestic range hoods with a maximum air flow in any of the available settings higher than 650 m3/h shall automatically revert to an air flow lower than or equal to 650 m3/h in a time tlimit as defined in Annex II.

(1)

From 18 months after the entry into force:

Power consumption in ‘off mode’: the power consumption in any off-mode condition shall not exceed 1,00 W.

Power consumption in ‘standby mode(s)’:

The power consumption in any condition providing only a reactivation function, or providing only a reactivation function and a mere indication of enabled reactivation function, shall not exceed 1,00 W.

The power consumption of equipment in any condition providing only information or status display, or providing only a combination of reactivation function and information or status display, shall not exceed 2,00 W.

Availability of ‘off mode’ and/or ‘standby mode’: domestic range hoods shall provide ‘off mode’ and/or ‘standby mode’, and/or another condition which does not exceed the applicable power consumption requirements for ‘off mode’ and/or ‘standby mode’ when the equipment is connected to the mains power source.

(2)

From 3 years and 6 months after the entry into force:

Power consumption in ‘off mode’: the power consumption in any off-mode condition shall not exceed 0,50 W.

Power consumption in ‘standby mode(s)’: the power consumption in any condition providing only a reactivation function, or providing only a reactivation function and a mere indication of enabled reactivation function, shall not exceed 0,50 W.

The power consumption of equipment in any condition providing only information or status display, or providing only a combination of reactivation function and information or status display shall not exceed 1,00 W.

Power management: when domestic range hoods are not providing the main function, or when other energy-using product(s) are not dependent on its functions, equipment shall, unless inappropriate for the intended use, offer a power management function, or a similar function, that switches equipment after the shortest possible period of time appropriate for the intended use of the equipment, automatically into:

‘standby mode’, or

‘off mode’, or

another condition which does not exceed the applicable power consumption requirements for ‘off mode’ and/or ‘standby mode’ when the equipment is connected to the mains power source.

The power management function shall be activated before delivery.

For range hoods with automatic functioning mode during the cooking period and fully automatic range hoods, the delay time after which the product switches automatically into the modes and conditions as referred to in the previous point shall be one minute after the motor and lighting have both been switched off either automatically or manually.

From 1 year after entry into force, for range hoods which provide for lighting of the cooking surface, the average illumination of the lighting system on the cooking surface (Emiddle) shall be higher than 40 lux when measured under standard conditions.

From 1 year after entry into force, the following product information shall be provided in the technical documentation of the product, the booklet of instructions and on the free access websites of manufacturers of domestic ovens, hobs and range hoods, their authorised representatives, or importers:

(a)

short title or reference to the measurement and calculation methods used to establish compliance with the above requirements;

(b)

information relevant to users in order to reduce total environmental impact (e.g. energy use) of the cooking process.

From 1 year after entry into force, the technical documentation and a part for professionals of the free access websites of manufacturers, their authorised representatives, or importers shall contain information relevant for non-destructive disassembly for maintenance purposes and information relevant for dismantling, in particular in relation to the motor, if applicable, and any batteries, recycling, recovery and disposal at end-of-life.

[1 kWh/cycle = 3,6 MJ/cycle.]

Symbol | Value | Unit

Model identification | | |

Type of oven | | |

Mass of the appliance | M | X,X | kg

Number of cavities | | X |

Heat source per cavity (electricity or gas) | | |

Volume per cavity | V | X | l

Energy consumption (electricity) required to heat a standardised load in a cavity of an electric heated oven during a cycle in conventional mode per cavity (electric final energy) | ECelectric cavity | X,XX | kWh/cycle

Energy consumption required to heat a standardised load in a cavity of an electric heated oven during a cycle in fan-forced mode per cavity (electric final energy) | ECelectric cavity | X,XX | kWh/cycle

Energy consumption required to heat a standardised load in a gas-fired cavity of an oven during a cycle in conventional mode per cavity (gas final energy) | ECgas cavity |

X,XX

X,XX

MJ/cycle

kWh/cycle

Energy consumption required to heat a standardised load in a gas-fired cavity of an oven during a cycle in fan-forced mode per cavity (gas final energy) | ECgas cavity |

X,XX

X,XX

MJ/cycle

kWh/cycle

Energy Efficiency Index per cavity | EEIcavity | X,X |

Symbol | Value | Unit

Model identification | | |

Type of hob | | |

Number of cooking zones and/or areas | | X |

Heating technology (induction cooking zones and cooking areas, radiant cooking zones, solid plates) | | |

For circular cooking zones or area: diameter of useful surface area per electric heated cooking zone, rounded to the nearest 5 mm | Ø | X,X | cm

For non-circular cooking zones or areas: length and width of useful surface area per electric heated cooking zone or area, rounded to the nearest 5 mm |

L

W

X,X

X,X

cm

Energy consumption per cooking zone or area calculated per kg | ECelectric cooking | X,X | Wh/kg

Energy consumption for the hob calculated per kg | ECelectric hob | X,X | Wh/kg

Symbol | Value | Unit

Model identification | | |

Type of hob | | |

Number of gas burners | | X |

Energy efficiency per gas burner | EEgas burner | X,X |

Energy efficiency for the gas hob | EEgas hob | X,X |

Symbol | Value | Unit

Model identification | | |

Type of hob | | |

Number of electric cooking zones and/or areas | | X |

Heating technology (induction cooking zones and cooking areas, radiant cooking zones, solid plates) per electric cooking zone and/or area | | |

For circular electric cooking zones: diameter of useful surface area per electric heated cooking zone, rounded to the nearest 5 mm | Ø | X,X | cm

For non-circular electric cooking zones or areas: length and width of useful surface area per electric heated cooking zone or area, rounded to the nearest 5 mm |

L

W

X,X

X,X

cm

Energy consumption per electric cooking zone or area calculated per kg | ECelectric cooking | X | Wh/kg

Number of gas fired burners | | X |

Energy efficiency per gas burner | EEgas burner | X,X |

Symbol | Value | Unit

Model identification | | |

Annual Energy Consumption | AEChood | X,X | kWh/a

Time increase factor | f | X,X |

Fluid Dynamic Efficiency | FDEhood | X,X |

Energy Efficiency Index | EEIhood | X,X |

Measured air flow rate at best efficiency point | QBEP | X,X | m3/h

Measured air pressure at best efficiency point | PBEP | X | Pa

Maximum air flow | Qmax | X,X | m3/h

Measured electric power input at best efficiency point | WBEP | X,X | W

Nominal power of the lighting system | WL | X,X | W

Average illumination of the lighting system on the cooking surface | Emiddle | X | lux

Measured power consumption in standby mode | Ps | X,XX | W

Measured power consumption off mode | Po | X,XX | W

Sound power level | LWA | X | dB