OBD stage I mandatory as of 2016 should not oblige manufacturers to change fuelling hardware and should not impose fitting of an electronic carburettor or electronic fuel injection, providing the vehicle complies with the requirements laid down in Regulation (EU) No 168/2013 and its delegated acts. Compliance with the OBD stage I requirements requires that if fuel delivery, spark delivery or intake air are electronically controlled, the applicable input and/or output circuits need to be monitored, limited to the items listed in Appendix 2 to Annex XII. If for example a motorcycle would be equipped with a mechanically actuated carburettor, but at the same time with electronically controlled spark delivery, the primary ignition coil circuits need to be monitored. In the case of a mechanical carburettor fitted with a throttle position sensor providing a circuit signal as input to the PCU/ECU to determine the engine load, which on its turn would be used to electronically control spark delivery, requires monitoring of that throttle position sensor circuit. Also other sensors and/or actuator circuits captured by points 3.3.5 and 3.3.6 of Annex XII will need to be monitored although not directly used to control fuel delivery, spark delivery or intake air. An example of such a case would be the wheel speed sensor circuits in case the vehicle speed would be calculated in the PCU/ECU from the wheel rotation speeds and which would subsequently be used to control the environmental performance of the motorcycle or would be used to trigger a torque limiting default mode.
Recital 12, Commission Delegated Regulation (EU) No 44/2014 of 21 November 2013 supplementing Regula…
In forcesince 21 Nov 2013