ANNEX IV, Commission Regulation (EU) No 814/2013 of 2 August 2013 implementing Directive 2009/125/…

In forcesince 2 Aug 2013

1.

For the purposes of compliance and verification of compliance with the requirements of this Regulation, calculations shall be made using harmonised standards the reference numbers of which have been published for this purpose in the Official Journal of the European Union, or using other appropriate calculation methods that take into account the generally recognised state-of-the-art methods. They shall meet the technical parameters and calculations set out in points 2 to 5.

Technical parameters used for the calculations shall be measured in accordance with Annex III.

The following parameters shall be calculated for water heaters under average climate conditions:

(a)

the water heating energy efficiency ηwh in %, rounded to one decimal place;

in addition, for solar water heaters under average climate conditions:

(b)

the annual non-solar heat contribution Qnonsol in kWh in terms of primary energy for electricity and/or in kWh in terms of GCV for fuels, rounded to one decimal place;

(c)

the heat generator water heating energy efficiency ηwh,nonsol in %, rounded to one decimal place;

(d)

the annual auxiliary electricity consumption Qaux in kWh, rounded to one decimal place.

(a)

Conventional water heaters and heat pump water heaters

The water heating energy efficiency is calculated as follows:

ηwh

Qref

Qfuel CC Qelec1 SCF smart Qcor

For water-/brine-to-water heat pump water heaters, the electricity consumption of one or more ground water pumps shall be taken into account.

(b)

Solar water heaters

The water heating energy efficiency is calculated as follows:

ηwh

0,6 366 Qref

Qtota

Where:

Qtota

Qnonsol

1,1 ηwh,nonsol 0,1

Qaux CC

(a)

The smart control factor is calculated as follows:

SCF1

Qfuel,week,smart CC Qelec,week,smart

Qfuel,week CC Qelec,week

(b)

If SCF ≥ 0,07, the value of smart shall be 1. In all other cases, the value of smart shall be 0.

The ambient correction term is calculated as follows:

(a)

for conventional water heaters using electricity:

Qcor kCCQelec1 SCF smart Qref

(b)

for conventional water heaters using fuels:

Qcor kQfuel1 SCF smart Qref

(c)

for heat pump water heaters:

Qcor k 24h Pstby

Where:

the k-values are given in Table 6 for each load profile.

3XS | XXS | XS | S | M | L | XL | XXL | 3XL | 4XL

k | 0,23 | 0,23 | 0,23 | 0,23 | 0,23 | 0,23 | 0,23 | 0,0 | 0,0 | 0,0