Products, parts, appliances, control and monitoring units and control and monitoring unit components shall be issued with certificates as specified in Annex I (Part 21).
By way of derogation from paragraph 1, certificates may be alternatively issued as specified in Annex I (b) (Part 21 Light) for the following products other than unmanned aircraft:
an aeroplane with a maximum take-off mass (MTOM) of 2000 kg or less and a maximum operational seating configuration of four persons;
a sailplane or powered sailplane of 2000 kg MTOM or less;
a balloon;
a hot air airship;
a passenger gas airship designed for not more than four persons;
a rotorcraft of 1200 kg MTOM or less and a maximum operational seating configuration of four persons;
a piston engine or fixed pitch propeller that is intended to be installed on an aircraft referred to in points (a) to (f); or
a gyroplane.
By way of derogation from paragraphs 1 and 2, a declaration of design compliance may alternatively be made, as specified in Annex Ib (Part 21 Light), for the following products other than unmanned aircraft:
an aeroplane of 1200 kg MTOM or less that is not jet-powered and with a maximum operational seating configuration of two persons;
a sailplane or a powered sailplane of 1200 kg MTOM or less;
a balloon designed for not more than four persons;
a hot air airship designed for not more than four persons.
By way of derogation from paragraphs 1 to 3 of this Article, aircraft, including any installed product, part and appliance, which are not registered in a Member State shall be exempted from the provisions of Subparts H and I of Section A of Annex I (Part 21) and Subparts H and I of Section A of Annex Ib (Part 21 Light). They shall also be exempted from the provisions of Subpart P of Section A of Annex I (Part 21) and Subpart P of Section A of Annex Ib (Part 21 Light), except where aircraft identification marks are prescribed by a Member State.